Anyone load for the .35 Remington?

Discussion in 'Ammunition & Reloading' started by cottontop, Jan 10, 2012.

  1. cottontop

    cottontop Guest

    I mentioned in the rifle discussion section that I might acquire a .35 Remington. It's in a Marlin Model 336 lever action. Any peculiar things that must be watched when reloading for it? I know flat or round nose bullets are required and the bullets should be crimped. What about neck sizing only?
    cottontop
     
  2. fmj

    fmj New Member

    3,459
    0
    0
    Its something that i need to get started doing....will be watching this thread closely.

    I have 2 .35 rems, dies, primers...just need bullets and proper powder.
     

  3. hiwall

    hiwall Active Member

    4,268
    20
    38
    I loaded 35's for many years. Nothing special about them. I always full-length resized (because I did not have a neck-only die). Not really many bullet choices. I used 200 gr. round nose about 95% of the time. Played around with 158 grain pistol bullets some(for a .357). I used 3031 powder mostly. Tried 150 gr. pointed bullets some( I only loaded 2 at a time). The 200 grain always shot the best in my guns.
     
  4. fmj

    fmj New Member

    3,459
    0
    0

    200 gr round nose sitting on how much 3031? What kind of results did you get with this recipe?
     
  5. robocop10mm

    robocop10mm Lifetime Supporting Member Lifetime Supporter

    11,380
    1
    0
    I have 3 boxes of .358's (180, 200,220) for the .35 Rem. PM for further.
     
  6. hiwall

    hiwall Active Member

    4,268
    20
    38
    "200 gr round nose sitting on how much 3031? What kind of results did you get with this recipe?"

    Sorry it has been many years(about 25) since I had a .35 Rem. I don't remember the load data.
     
  7. fmj

    fmj New Member

    3,459
    0
    0
    OK cool, i'll just dig it up in the manuals!