Anyone know the size or part number of a Winchester 94AE top rear plug screw ??

Discussion in 'General Rifle Discussion' started by Gh0zt36, Sep 22, 2020.

  1. Gh0zt36

    Gh0zt36 Well-Known Member

    1,616
    65
    48
    Rifling82 likes this.
  2. c3shooter

    c3shooter Administrator Staff Member Admin Moderator Lifetime Supporter

    25,593
    15,536
    113
    Pretty sure that is the right screw- less than half the price from Numrich.

    SIGHT PLUG SCREW, TELESCOPIC, NEW FACTORY ORIGINAL (4 REQ'D)

    $4.85
    Manufacturer: WINCHESTER
    Model: 94 ANGLE EJECT STANDARD, TIMBER CARBINE
    Product #: 1304100B
     
    Gh0zt36 likes this.

  3. primer1

    primer1 Well-Known Member Supporter

    11,689
    3,849
    113
    If you have the same luck I do, you'll find the old ones on the same day the new ones come in the mail.
     
    Rifling82 and Gh0zt36 like this.
  4. Gh0zt36

    Gh0zt36 Well-Known Member

    1,616
    65
    48
    Isnt that how it always works out lol
     
    Rifling82 likes this.
  5. c3shooter

    c3shooter Administrator Staff Member Admin Moderator Lifetime Supporter

    25,593
    15,536
    113
    FWIW Mossbers used to use a red/green platic peg for the safe/fire indicators on their 22 rifles- and they frequently go adrift. Since I have restored several of these, found a source of the pegs for a buck each- to avoid high shipping costs, ordered 10 of each.

    Now if I could remember WHERE I PUT the bleeding things.......
     
    primer1 likes this.
  6. Hookeye

    Hookeye Well-Known Member

    3,468
    2,534
    113
    Most any good gunshop will have plug screws. I like the ones that have a stop to them. Think Lyman had little tubes of em back in the day.

    I know Im about empty, have given some to buds and to the LGS
     
  7. Hookeye

    Hookeye Well-Known Member

    3,468
    2,534
    113
    Took a couple spare Rem shotgun mag caps over too.
    Tired of that stuff in my toolbox.
    If I buy a new gun and scope it, it stays scoped, so had a few sets of plug screes around. Spare rings too.
    Got a blued Ruger set on the kitchen counter LOL.
     
  8. c3shooter

    c3shooter Administrator Staff Member Admin Moderator Lifetime Supporter

    25,593
    15,536
    113
    If I take a plug screw out, I wrap the in a bit of paper, tape it closed, remove buttplate and place them in the hollow of the stock. Might want it some day, and it stays with the gun.
     
    Rifling82 likes this.