A question on removing a pin....

Discussion in 'General Shotgun Discussion' started by Westy, Aug 31, 2012.

  1. Westy

    Westy New Member

    406
    0
    0
    I have a Savage 320 that I want to put a scope mount on, and it requires removing the receiver pin. Since there isn't and screw slots on the pin, how does a guy remove these? It isn't going to fly apart on me is it? The head is larger on one side than the other.

    Any help would be appreciated!
     

    Attached Files:

  2. mountainman13

    mountainman13 New Member

    11,488
    0
    0
    Bang it out from left to right. It holds your trigger assembly in. No big deal.
     

  3. Westy

    Westy New Member

    406
    0
    0
    Thanks, I'll give it a go. Now if only I could reverse the safety.... (Lefty). :D
     
  4. mountainman13

    mountainman13 New Member

    11,488
    0
    0
    Not sure on that model. Might be possible.
     
  5. tonydewar

    tonydewar New Member

    619
    0
    0
    you should be able to just study the trigger group. if the holes are the same size its just a matter of flipping the button. check out beretta 390