Firearms Talk banner

1 - 5 of 5 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
reloading, feed problems with mod 94 and is there an issue with shorting the case neck below spec. hornady writes may be .01 below sammi spec. my issue is will it cause high chamber pressure? Thoughts......
 

·
Administrator
Joined
·
26,303 Posts
Stubs- moved your question over to rifles- you were in the website section.

The leverlution ammo should cause no problems with chamber pressure increase.
 

·
Premium Member
Joined
·
7,757 Posts
The 30-30 head spaces on the rim so you can shorten the neck if necessary and have no affect on an 'pressure'. If you are worried about seating depth, that to should not be a problem if you stay in safe ranges with your charges. When I was shooting the 45-70 I noticed the cases which I retrieved from the factory Flex tip ammo were much shorter than the normal brass I use.
 

·
Premium Member
Joined
·
16,833 Posts
The 30-30 head spaces on the rim so you can shorten the neck if necessary and have no affect on an 'pressure'. If you are worried about seating depth, that to should not be a problem if you stay in safe ranges with your charges. When I was shooting the 45-70 I noticed the cases which I retrieved from the factory Flex tip ammo were much shorter than the normal brass I use.
Yeap , Re loaders hate them ! Like the Hornady 325 gr. 45-70 GOVT. FTX !
 

·
Registered
Joined
·
4 Posts
Discussion Starter #5
(Yeap , Re loaders hate them ! Like the Hornady 325 gr. 45-70 GOVT. FTX !)

dango: whats that supposed to mean....

JimRau: Thanks for the responce. I feel comfortable with shorting the casing a little but wanted a second opinion. I like to bend toward the side of safety first..
 
1 - 5 of 5 Posts
Top