10/22 into a AK47

Discussion in '.22 Rifle/Rimfire Discussion' started by defcon, Jun 16, 2012.

  1. defcon

    defcon New Member

    281
    0
    0
    10/22 into a full metal AK47 airsoft stock

    Just got out of surgery.

    It's about 80% done right now. Need to clean everything up and repaint it flat black. MOE stock will be plasti dipped in black.
    The 10/22 rotary mag was JB welded to the AK47 magazine.

    I had to dremel off the left wall of the AK47 receiver in order for the 10/22 to slide right in. I will then create brackets on both sides of the left wall of the receiver.
    Will be reusing the action screw under the barrel and using an extended bolt through the buffer to keept it steady. WIll be using steel epoxy putty to bed the rest of the action and barrel.

    I'm looking for a AK47 muzzle brake and front sight.


    Saiga quad rail
    Magpul
    Magwell grip
    Magpul sights
    ACOG clone
    MOE stock
    MOE cheek riser
    Marauder fake silencer






    [​IMG]
    _MG_2372 by defconskylude, on Flickr


    [​IMG]
    _MG_2376 by defconskylude, on Flickr

    Cover off
    [​IMG]
    _MG_2377 by defconskylude, on Flickr


    Cover on
    [​IMG]
    _MG_2378 by defconskylude, on Flickr

    [​IMG]
    _MG_2379 by defconskylude, on Flickr





    [​IMG]
    _MG_2374 by defconskylude, on Flickr

    [​IMG]
    _MG_2373 by defconskylude, on Flickr

    [​IMG]
    _MG_2371 by defconskylude, on Flickr
     
    Last edited: Jun 16, 2012
  2. Jkl-28

    Jkl-28 New Member

    175
    0
    0
    Wow! That's a really good looking 10/22 man!
    You did one hell of a job with that!
     

  3. defcon

    defcon New Member

    281
    0
    0
    thanks
    it took some planning to make this work. i didnt think i could do it because the receiver is 1 inch wide while the 10/22 receiver is 1.25 inches wide.

    its going to look a whole lot better when its finally painted and cleaned up.