1. 
   

   Another Whippet question..

   I have a Whippet Model C, Bolt action single shot .22 lr. I think the sear is wore too far, When I pull the cocking mechanism back it won't stay.. but if I lift the bolt up a little it will stay cocked until you push the bolt back down.. I know this is a very inexpensive rifle but I have fond Memories from back in the early 60's with my Grand dad and Dad lighting stick matches with the .22's ,...

   glockman55 Oct 26, 2020 at 12:27 PM Read More Replies: 3
2. 
   tractor_guy

   Looking for Whippet info

   I have my father-in-laws old slide action Whippet .22 by H. S. B. & co. It shows some wear in the hammer were the plunger goes as well as to the tip of the plunger. This causes the plunger to pop out of th hole and jam up the works. The gun also occasionally fails to lock in th cocked position. I am unsure if this is a hammer or trigger or both wear condition. My research so far says that...

   tractor_guy Oct 25, 2020 at 7:02 PM Read More Replies: 3
3. 
   jdsingleshot

   How does a Sako safety work?

   I need to make a Sako type extractor. I have this image of that setup, but can somebody tell me about the pivot hole and the pin that gazinta it? Is the hole, or the pin/boss tapered to allow the extractor to pivot up at the hook, or is there some other provision to let that happen?

   jdsingleshot Oct 25, 2020 at 12:12 PM Read More Replies: 0

Your name or email address:

Do you already have an account?

• No, create an account now.
• Yes, my password is:
• Forgot your password?

Stay logged in