Bond Arms Derringer Grip Replacement

Discussion in 'General Handgun Discussion' started by rengelm2, Mar 12, 2012.

  1. rengelm2

    rengelm2 New Member

    2
    0
    0
    This should be easy to everyone out there buy me. I purchased a bond arms snake slayer derringer and am now trying to replace the grip. I have removed the one screw which I thought was hold the grip on, but after removing the screw, I still cannot remove the grip. There must be a simple trick to removing the grip, but I have yet to figure it out. I would appreciate any help or suggestions. I am new to getting involved with guns, so don't think this is such a basic question that noone will pay any attention to it.
    Please help.
     
  2. HOSSFLY

    HOSSFLY New Member

    6,932
    0
    0
    No real trick- Just ned to CAREFULLY pry off :)
    SHARP knife tip will work- CAREFULLY :rolleyes:
     

  3. rengelm2

    rengelm2 New Member

    2
    0
    0
    Prying off was the key. There were two pins, one on each half of the grip. Since the grip is wood, they were in there pretty tight making the separation more difficult. But thanks again.