VIEW MY

Uncle_McPeanut

Gift Premium Subscription To Uncle_McPeanut

Join Date:

01-12-2011

Last Activity:

10-04-2011 6:56 AM

    ABOUT ME

  • good evening everyone.... ....testicles.... ...that is all
  • townsville australia,QLD Queensland
  • everything
  • student

LATEST ACTIVITY

  • Posted in thread: confused with 22 barrel to round tolerances on 01-22-2011 at 03:12 PM
    how have you made 9700 posts and you joined later the c3 how often do you go on this sight?

  • Posted in thread: confused with 22 barrel to round tolerances on 01-22-2011 at 03:08 PM
    cool thank you thats the answer i wantedive worked in the engineering trade for a bit and
    learned about tolerances and it just seemed a bit weird that the bullet was bigger than the id
    of the bore but...

  • Posted in thread: confused with 22 barrel to round tolerances on 01-20-2011 at 04:48 AM
    hi ive done a bit of research and found that the round is slightly larger than the crest of the
    twist and is size for size or a tiny size smaller that the valleyillustration : : : vv. v

  • Posted in thread: designing a rifle need rough tolerences for .50 cal on 01-18-2011 at 04:33 AM
    this is what the trigger system looks likethat pole connected to the hammer is spring tensioned
    into that cylinder at the bottom kinda like the 1911 hand gun and the hammer release is spring
    with a pi...

  • Posted in thread: designing a rifle need rough tolerences for .50 cal on 01-18-2011 at 04:15 AM
    yeah i think doing a 50cal was a bit enthusiastic though luckily Ive only got the trigger
    system and about half the bolt done so i only need to adjust the pin for the 22 and i should be
    good in that c...

  • Posted in thread: designing a rifle need rough tolerences for .50 cal on 01-17-2011 at 06:45 AM
    i still kinda want those tolerances ie. what size the round is compared to the barrel without
    twist is it size for size or is there a .001 or .01 mm clearance between the two and info on
    twists would ...

  • Posted in thread: designing a rifle need rough tolerences for .50 cal on 01-12-2011 at 01:27 PM
    lol its only a little project nothing serious but if the design works out i might try it and
    the only reason im doing it with 50 cal is its easier to design cause the measurements arn't
    that minute, s...

  • Posted in thread: designing a rifle need rough tolerences for .50 cal on 01-12-2011 at 12:35 PM
    hi im designing a bolt action rifle and i would like to know the estimated tolerances for a
    .512 or 13.0048mm respective round in a 782 mm long barrel without twist (ill get to that later
    on in the de...

0 COMMENTS
POST A COMMENT