TINCANBANDIT

Gift Premium Subscription To TINCANBANDIT

Join Date:

01-02-2014

Last Activity:

06-24-2017 10:45 PM

Likes Given: 6

170 Likes on 103 Posts 

LATEST ACTIVITY

  • Posted in thread: Yet another 10/22 project on 06-16-2017 at 08:35 PM
    Blog post catching up with this thread

  • Posted in thread: Show off those refinished guns!! on 06-05-2017 at 09:24 PM
    Steyr 9mm pistolI didn't get a picture before the metal was sanded, but here it is before and
    after bluing

  • Posted in thread: Yet another 10/22 project on 05-30-2017 at 01:10 AM
    I covered the barre/receiver junction with tape and a liberal coating of car wax to prevent the
    JB weld from sticking to it mixed up the JB weld and put some under the washer and on top,
    when the bar...

  • Posted in thread: Yet another 10/22 project on 05-30-2017 at 01:02 AM
    I then cleaned the end with some 400 grit sand paper and my thumb....which now sports a
    blister... noticed that for some reason the barreled receiver fit very tight in this stock, I
    got out the lamp ...

  • Posted in thread: Yet another 10/22 project on 05-30-2017 at 12:57 AM
    I just posted part 3 to my blog (which is lagging behind the posts here) are some more
    updatesI need to shorten the barrel and recrown the muzzle. By law a rifle barrel must be 16"
    or longer (unless ...

  • Posted in thread: Show off those refinished guns!! on 05-24-2017 at 11:28 PM
    '60's vintage Savage 110 in 30-'06, picked it up for cheap. I did the camo paint with Krylon
    and some cedar branches

  • Posted in thread: Show off those refinished guns!! on 05-23-2017 at 03:31 PM
    I took a pile of parts and built this Ruger 3-screw Blackhawk and installed a Colt 1851 Navy
    brass grip frame post: is what I started with, the brass birdshead grip frame was for a New
    Model Blackh...

  • Posted in thread: Yet another 10/22 project on 05-19-2017 at 02:33 PM
    Then I drilled the holes and temporarily mounted it, the bolts will be trimmed after I figure
    out how to use them to secure the barrel shroud as well. it is with both fore and aft grips
    and the butt ...

  • Posted in thread: Yet another 10/22 project on 05-19-2017 at 02:31 PM
    While the JB Weld was curing, I started on the front picatinney mount. The 10/22 stock has a
    rounded bottom, I'll need to flatten it out some some work with the file I marked the center
    line

  • Posted in thread: Yet another 10/22 project on 05-19-2017 at 02:28 PM
    After sanding and radiusing the edges, I glued a piece of flip flop to the plate it cured, I
    trued up the two using the 400 grit belt on the belt sander I started figuring a way to
    connect the butt ...

Following Stats
0 COMMENTS
POST A COMMENT