VIEW MY

teenahlake

Gift Premium Subscription To teenahlake

Join Date:

07-25-2012

Last Activity:

05-04-2014 12:32 PM

Likes Given: 1

1 Likes on 1 Posts 

LATEST ACTIVITY

  • Posted in thread: identify this tool please on 05-04-2014 at 03:48 PM
    Deleted still searching

  • Posted in thread: 8mm Mauser vs .308 Winchester on 05-04-2014 at 03:47 PM
    The military sights shoot high so as to allow a greater point blank range ie: all shots within
    say 6" of poa out to 300m find a higher front sight or have a smith brazen a piece of brass on
    top. 2nd p...

  • Posted in thread: DHS Checkpoints on 04-11-2014 at 04:31 PM
    walked up to departure level at airport, saw the CBSA"cdn CBP" at top of stairs. I rolled my
    eyes, buddy took that as reason to question me. Asked for my boarding card looked at it and
    asked for my pa...

  • Posted in thread: 222 vs 22 mag on 05-05-2013 at 11:48 PM
    because a worn crown/rifling will affect accuracy, cutting it back will normally clean it up,
    and rechambering to 223 will #1 make it easier to find ammo, and#2 clean up the leade once
    again possibly ...

  • Posted in thread: Anybody seen this shotgun? on 05-05-2013 at 11:30 PM
    [ame=" fun

  • Posted in thread: 222 vs 22 mag on 05-05-2013 at 11:25 PM
    If the crown is worn, I would probably cut it back an inch, and since any collector value is
    now moot, rechamber to 223

  • Posted in thread: reboring 30-30 to 32 special on 05-05-2013 at 11:15 PM
    is there enough meat to rebore/rifle providing pitting isn't too bad?

  • Posted in thread: Saving Grandpa's Pig Gun on 05-05-2013 at 11:13 PM
    get a bore sleeve form brownells, and the drill, bore out epoxy in place refinish the muzzle
    most original, but maybe have 2 bbls

  • Posted in thread: Chicken coop.... on 03-28-2013 at 03:17 AM
    throw all your kitchen scraps at them too, line the bottom of there run with grass clippings
    and leaves, makes for easier cleanup, better compost

  • Posted in thread: M98 action question on 03-28-2013 at 03:04 AM
    changes needed include but not limited to, opening bolt face, relieving feed rails, possible
    new mag box. Unless your DIYing it will probably cost more than a new one from CZ

0 COMMENTS
POST A COMMENT