Stacheyboots

LATEST ACTIVITY

• Posted in thread: new frontier poly lower on 03-01-2013 at 03:42 PM
  Can't we all just get along? I personally just built my AR. I could have gone with a poly lower
  and it might have been fine. However after speaking with multiple gunsmiths, i was informed
  that the pol...

• Posted in thread: AR-15 Parts? on 02-22-2013 at 06:58 PM
  I actually live rather close to PSA so I can just go check em out and maybe get somethings
  while im there.

• Posted in thread: AR-15 Parts? on 02-22-2013 at 06:40 PM
  I have been on the hunt for a lower parts kit at an affordable price. The issue is if i find
  them they are on backorder or out of stock and discontinued. Can anyone tell me where I may be
  able to find...

• Posted in thread: Leaving your XD mags fully loaded..Good or bad? on 02-22-2013 at 06:36 PM
  I have personally seen it cause issues with 92f mags. We were taught to rotate our mags
  periodically.I have jept my 92fs loaded for a lil over a year now, and i havent had any issues.
  Not saying it do...

• Posted in thread: Windage adjustments bases on 02-22-2013 at 05:49 PM
  I always use some loctite. I do not have such a hard hitter as yours, but, with mine, I never
  had the screws come loose.I also do not retighten screws. The torque applied the first time
  does stretch t...

• Posted in thread: polishing feed ramp on 02-22-2013 at 05:45 PM
  Oh and just in case anyone is looking at the remington R1's, those feed ramps arent even
  polished at the factory, and you will play hell trying to feed hollow points in them. Not a
  problem if you know...

• Posted in thread: polishing feed ramp on 02-22-2013 at 05:39 PM
  No i wasnt having any feeding issues, i re-blued the frame, so in turn i had to clean up the
  feed ramp, disconnector rail, and then did a trigger job on it. All of this meant lots of time
  getting the ...

• Posted in thread: polishing feed ramp on 02-22-2013 at 05:03 PM
  I just polished my feed ramp on my 1911. I used a foredom tool with a foot pedal for speed
  control. I used a piece of 1/8 in drill rod that i split down the middle with a really small
  jewelers saw. I ...

• Posted in thread: 1911 hammer pin issue on 02-21-2013 at 05:03 PM
  Really? It came from factory this way and there is a cavity to fit the side of the hammer pin
  that has a head on the starboard side of the pistol to make it flush with the frame. (Not to
  mention the b...