Last Activity:11-22-2016 8:59 PM
18 Likes on 16 Posts
Posted in thread: New 6.5 Grendel question. on 07-03-2016 at 08:56 PM
Sniper03, Thank you for the info. These were indeed PPU factory loads. The cases are not split,
they are marred from the outside for some reason. And there are pretty rough extractor marks on
Posted in thread: New 6.5 Grendel question. on 07-03-2016 at 08:38 PM
Thanks Tikki,I was shooting factory ammo. I was shooting PPU 110grn BTFMJ ammo. The cases are
not split they just have a drag mark in the neck. It is an Odin works match grade barrel and
Posted in thread: New 6.5 Grendel question. on 07-03-2016 at 12:09 AM
I finally got a chance to get my Frankenbuild 6.5 Grendel to the range today. First let me say
I love the round and the rifle is very accurate if I do my part. However, it was not 100%
reliable. I had...
Posted in thread: P229 enhanced elite.....failures on 01-30-2016 at 02:13 AM
Well I spent some more time at the range and she's on her way back to Sig, more failure to
extract/ double feed issues just like before. I had to pay shipping since I'm not the original
owner. Was tol...
Posted in thread: P229 enhanced elite.....failures on 01-16-2016 at 12:02 PM
I had the same issues with a brand new enhanced elite p229. Sent it back to Sig and they
replaced the extractor and extractor spring and ran flawlessly after that.Thanks, how was your
experience with ...
Posted in thread: P229 enhanced elite.....failures on 01-14-2016 at 09:01 PM
Just a quick update. I went back to the range and fires only quality 124gr ammo and a box of
defensive +p Hornady. I was extra careful about my strong hand thumb position after watching
this video by ...
Posted in thread: P229 enhanced elite.....failures on 01-12-2016 at 01:07 PM
Picked up a "new to me" sig p229 enhanced elite this past weekend. Previous owner stated he put
around 500-600 Rds through it with no issues. Imagine how excited I was to get to the range
with this. ...
Posted in thread: New Baretta Nano problem. on 07-21-2015 at 11:06 PM
Just got home with my new Nano a while ago and cleaning the grease off. I have a problem with
the One of the Mags. The 6rf flush mag goes in smoothly with normal amount of force but the 8
rd mag with ...
Posted in thread: Taper pin hole in barrel? on 03-01-2015 at 03:56 PM
After much cursing and purchasing a new 4lb blacksmith hammer! I finally was able to get my A2
front off my M&P 15 sport. Installed a new YHM low profile gas block and MOE hand guard. (Love
the look o...
Posted in thread: canik Stingray C or Bersa Thunder 9mm on 01-13-2015 at 10:53 PM
Just sold a Tristar c-100 which is very similar to stingray C (both made by Canik out of
Turkey) it was a quality gun but I would vote Bersa strictly because if you ever Trade or sell
the Bersa should...