Gift Premium Subscription To Professor

Join Date:


Last Activity:

08-12-2016 10:23 AM

Likes Given: 24

13 Likes on 11 Posts 


  • Posted in thread: AR "pin bushings" Where can I get? on 08-12-2016 at 02:23 PM
    I'm planning on attaching a "large pin" upper receiver to a "small pin" )mil-spec) lower. I've
    been told that there are pin bushings available to do that. Can anybody tell me where I can buy

  • Posted in thread: Mauser case-forming question on 10-07-2014 at 01:49 PM
    I will start by saying that I am relatively new at reloading, but understand the basics and
    have had some success. This is my first attempt at case-forming. I have a 7.65 Argentine Mauser
    and I am usi...

  • Posted in thread: Newbie: What's a Modified Choke? on 06-25-2014 at 02:32 AM
    Thanks for all the helpful input. Especially for the ball-busting because I
    asked such an elementary (newbie) question. Actually, I am reasonably knowledgeable in some
    other areas of fi...

  • Posted in thread: Newbie: What's a Modified Choke? on 06-23-2014 at 10:35 PM
    My uncle wants to give me a single-shot 20 gauge (Pardner model) shotgun. The barrel says 3
    inch "Modified choke". I know how "newbie" this question is but, not knowing much about
    scatterguns, can any...

  • Posted in thread: Least expensive reloading setup for .223 on 05-31-2014 at 03:52 PM
    Speaking of those Lee scoops, I acquired a bunch of different sizes, when I acquired my used
    reloading equipment. Because I was new, I wasn't even sure what they were and I almost threw
    them out. I di...

  • Posted in thread: Mil-spec FMJ vs Civ FMJ and TMJ vs CMJ on 05-26-2014 at 12:15 PM
    1st) Thanks for the clarifications on pulled bullets.........2nd) regarding TMJ being safer:
    well yeah, it is....BUT....I think that the danger from exposed (to burning gases) lead is
    SLIGHTLY over st...

  • Posted in thread: Mil-spec FMJ vs Civ FMJ and TMJ vs CMJ on 05-25-2014 at 11:26 PM
    Speaking of pulled ammo (question directed toward Jon), how IS pulled ammo? I see a lot of it
    for sale, but am not sure how "damaged" it is from the pulling process. (These bullets would be
    used for g...

  • Posted in thread: .223 Powder Choices ? on 05-23-2014 at 05:33 PM
    New to reloading (and loving it). I've done a few thousand pistol rounds and a few thousand
    .223 rifle rounds. Regarding the .223, I had been using some Hodgdon H335 powder that I
    acquired with the us...

  • Posted in thread: "Slugging the Bore" question on 05-11-2014 at 01:39 PM
    Thanks, nhsuper44. Live Free or Die, indeed.

  • Posted in thread: "Slugging the Bore" question on 05-03-2014 at 01:28 AM
    I may have misunderstood...or I may have repeated it incorrectly. According to the advice I was
    given if bullet diameter is LARGER than groove diameter (too tight a fit) it can lead to
    dangerously hig...