VIEW MY

Pounce

Gift Premium Subscription To Pounce

Join Date:

08-14-2007

Last Activity:

08-31-2017 8:46 AM

Likes Given: 12

91 Likes on 65 Posts 

    ABOUT ME

  • SC
  • Retired..6/05

LATEST ACTIVITY

  • Posted in thread: 1911 .380 Baby Rock on 08-31-2017 at 02:32 PM
    I am going to see about sending m M-91 back to Russia to see if they will fix the barrel band
    that is just too tight....Reckon they will send me the box?I had to supply my own box. They
    supplied the l...

  • Posted in thread: 1911 .380 Baby Rock on 08-31-2017 at 12:46 PM
    Bill, ain't nobody gonna listen to you....these days is all about SENDING IT BACK for the least
    little thing!That's most correct. If you mess with it, you negate the warranty. Not a smart
    thing to do....

  • Posted in thread: 1911 .380 Baby Rock on 08-21-2017 at 10:24 PM
    Yep..yer all correct. (except making a new pin)I called them up 'after' my post and they are
    gonna send fed x with a label box etc. Thanks for the replies! Ron

  • Posted in thread: 1911 .380 Baby Rock on 08-21-2017 at 12:40 PM
    I just got this about 4 months ago and only fired about 200 rounds in it. The ejector pin fell
    out to where, I do not know. The ejector flops out and the gun is useless as is. Has anyone had
    that prob...

  • Posted in thread: trigger spring on 05-06-2017 at 12:22 PM
    There is an action block safety on the breech end of the Base Pin assembly. The small spring
    loaded tip if damaged can cause the sear to lock up.:)Mr. Wright suggested turning the trigger
    pivot screw ...

  • Posted in thread: trigger spring problem? on 05-05-2017 at 10:13 PM
    Try backing off the hammer pivot screw about half a turn.Bob WrightWell,Kiss my grits!!!!! I
    did did as you stated to do about 2 min ago. Popped off a few rnds. It worked!!!I had tightened
    up that and...

  • Posted in thread: trigger spring on 05-05-2017 at 07:32 PM
    Is there any tension as you cock the hammer? Are you saying that the hammer just sort of flops
    down?Remove the grips and see if you see the spring and strut. If there is a spring assembly,
    look at the...

  • Posted in thread: trigger spring problem? on 05-05-2017 at 07:28 PM
    When I pull the hammer back it is fine. I had the grips off and the hammer spring and strut
    looks and works as it should. Lots'a good tension. Just no snap when the trigger is pulled. As
    i stated,with...

  • Posted in thread: trigger spring problem? on 05-05-2017 at 04:45 PM
    Maybe I am confused.I thought the transfer bar rose up and "filled the gap" between the hammer
    and firing pin when the trigger was pulled. Otherwise, it would stay down as a safety feature
    and the ham...

  • Posted in thread: trigger spring on 05-05-2017 at 04:06 PM
    I posted on the ruger forum...I have a 3 screw blackhawk .357 that the hammer won't drop when
    pulling the trigger. Only pointing down and a little nudge makes it drop. Trigger spring? I
    ordered a kit ...

0 COMMENTS
POST A COMMENT