VIEW MY

nottelybill

Gift Premium Subscription To nottelybill

Join Date:

06-30-2010

Last Activity:

02-24-2014 1:54 PM

LATEST ACTIVITY

  • Posted in thread: polishing stainless steel matt finish pistol on 04-19-2014 at 07:56 PM
    yes like brushed. these two guns are for carry. I have others I shoot outside with mostly.
    thanks

  • Posted in thread: polishing stainless steel matt finish pistol on 04-19-2014 at 07:39 PM
    I have 2 Taurus matt finish pistols and I would like to brighten them up just a bit. Not till
    they are shinny. How can I do this?

  • Posted in thread: Kel-Tec SU-16 trigger job?? on 07-09-2012 at 01:36 PM
    Has anyone done a trigger job on the SU 16. I have had mine apart twice trying to smooth out
    and reduce trigger pull but it is not still not smooth or chrisp.

  • Posted in thread: Ruger 44 Mag. Carbine trigger job? on 11-09-2011 at 02:53 PM
    I have one of the earlier models of the Ruger 44 mag Carbines and the trigger has a lot of
    creep and is rough and heavy. I have worked on it a little but as with most guns there are
    somethings that ca...

  • Posted in thread: Marlin Papoose or Henry survival rifle- which one?? on 08-21-2011 at 05:25 PM
    of these 2 rifles, the marlin papoose and the henry survival rifle which is the best all around
    rifle? Money not a consideration.

  • Posted in thread: Ruger Carbines and twist rate?? on 03-20-2011 at 03:20 PM
    I have an old model tube fed Ruger 44 carbine and a Deerfield. Everyone seems to think the 240
    and over grain bullets work the best. I have some 180 Remington and some 200 grain Fiocchi that
    are prett...

  • Posted in thread: looking for Ruger factory mounts for 44 deerfield on 03-06-2011 at 06:33 PM
    I am trying to find a pair of ruger scope mounts for the Ruger 44 deerfield scope mounts. any
    help out there?

  • Posted in thread: Ruger 44 carbine gas block screw size?? on 02-26-2011 at 11:22 AM
    Thanks Stalkingbear. I found out they are IIRC 40TPI still not sure of diameter.

  • Posted in thread: Ruger 44 carbine gas block screw size?? on 02-24-2011 at 04:16 PM
    I still need to know scew size so i can the a tap and clean up the threads in the gas block
    itself.

  • Posted in thread: Ruger 44 carbine gas block screw size?? on 02-24-2011 at 03:21 PM
    --------------------------------------------------------------------------------I need to know
    what the screw size is for the adj. screw that goes into the gas block on my Ruger 44 carbine.
    Mine was c...

0 COMMENTS
POST A COMMENT