Gift Premium Subscription To Misfire51

Join Date:


Last Activity:

06-26-2015 5:10 PM

Likes Given: 15

14 Likes on 11 Posts 


  • Peoria, Arizona


  • Posted in thread: trigger group problems on 06-17-2015 at 06:55 PM
    I've always had good luck with Rugers c/s dept. Glad to here that they took care of you.

  • Posted in thread: Another Plus For 300 BO Mini? on 05-25-2015 at 04:59 PM
    sandog , really like the way your m30 has evolved , Where did you buy the sling from, it looks

  • Posted in thread: New Mini-30 Owner on 05-05-2015 at 11:42 AM
    Sandog, good info on the stain. I will pick up some walnut so I don't have to sand and start
    over.As far as ammo goes , the Tula ammo in 223 has boxer primers but its still pretty crappy
    stuff. I don'...

  • Posted in thread: New Mini-30 Owner on 05-03-2015 at 06:38 PM
    That Baby's lookin good. I stripped down my older mini curved stock to re stain it. That
    Factory stain is a bear to get off. I first hit it with a walnut stain and then took a blacking
    stain for the h...

  • Posted in thread: Mini 14 brass on 04-30-2015 at 07:48 PM
    Oh I will make some adjustments to the gas port bushings but not until I have run about 500
    rnds thru it. I want to make sure that this Mini is rock soild.

  • Posted in thread: Mini 14 brass on 04-30-2015 at 01:40 AM
    Upon shooting my new 583 series Tactical , I noticed that all my brass was in one pile about
    15' away , none of the brass had any damage at all , not like I used to get. Maybe my bolt ,
    which I notice...

  • Posted in thread: Interesting ‘Eye to Sight’ Length Discovery on 04-30-2015 at 01:31 AM
    I have long arms , so that does not work for me. Glad you figured it out.

  • Posted in thread: So I'm Thinkin The LOP is Too Long on My Mini-14 . . . . on 04-30-2015 at 01:29 AM
    Looks great Steve. stole a page from your play book and drilled out my safety to match the M1A.
    Great observation my friend. My new Mini looks complete now. All these years and I could not
    figure out ...

  • Posted in thread: trigger group problems on 03-26-2015 at 09:49 PM
    Make sure the trigger is cocked before trying to dissemble or reassemble. After you remove the
    trigger you do not have to snap the guard back , leave it the way it was when you took it out.
    Hope this ...

  • Posted in thread: New Toy on 03-26-2015 at 09:36 PM
    I always use a butane pencil torch, only heat the screw, it will melt the Loctite. Don't like
    banging on my guns unless necessary. I just got a call from Rugers c/s . They are going to send
    me a brand...

Tony/ Mighty Arms, Firearms & Accessories