Last Activity:11-12-2013 11:55 AM
2 Likes on 2 Posts
Posted in thread: Glock 19 on 07-31-2013 at 02:45 AM
I got my Glock 19 about six months ago and no problems.I put a set of green Tru Glow sights on
it and made a world of difference shooting IDPA. While I was at the gun shop getting my sights
put on, on...
Posted in thread: AR picture thread on 06-05-2013 at 01:52 AM
I have a 16" barrel on my dpms just need to buy a low profile gas block and the rail? RightYes
sir. It's comes with it's own barrel nut and wrench for installation.
Posted in thread: AR picture thread on 06-03-2013 at 05:54 PM
What rail is that? Size and all I want to purchase one for my dpmsWell that's a vltor VIS-3
rifle length upper. The rail and upper is one piece. To have that setup it will run in the
6-700 dollar rang...
Posted in thread: AR picture thread on 05-31-2013 at 06:42 PM
103538Finally got me a little rds that'll hold me over until an aimpoint/eotech
Posted in thread: St-T2 in a commercial buffer tube??? on 03-01-2013 at 02:15 AM
With the added spring pressure, it COULD cause short stroking issues, to make it short and
sweet. But, I am no where near an expert on buffer weight/springs when it comes to choosing the
right combo f...
Posted in thread: AR picture thread on 02-28-2013 at 02:24 AM
Here's my first go around with it. It was a lot of fun. A great learning experience. All pain
work is Brownell's Alumahyde II. All magpul furniture. Billet upper and lower. 2 stage trigger.
Posted in thread: Completed my first build on 02-26-2013 at 04:20 AM
I really like it! Looks similar to my build: 87637
Posted in thread: P-mag with window on 02-20-2013 at 11:59 PM
And what, pray tell is this magical place called? Where might it be? Hrm?I didn't post the name
of the shop at the time because we're out now :P but we're located in western Kentucky.
Posted in thread: AR picture thread on 02-20-2013 at 04:03 AM
New rail cover I just picked up online. Pretty neat and only 25 bucks! 86429
Posted in thread: Muzzle Brake Alignment on 02-18-2013 at 04:38 AM
When I installed my dynacomp, it was off just like yours is. I just took sand paper, laid it on
a flat surface, and ran the crush washer over it to take off enough material to where the comp