Last Activity:01-19-2014 10:32 AM
1 Likes on 1 Posts
Posted in thread: Strange .22 firing problem... on 04-25-2013 at 10:58 PM
Porn! You want porn! I got your porn right here!
Posted in thread: Strange .22 firing problem... on 04-25-2013 at 10:34 PM
Hmmm...I noticed something else. There seems to be a little powder residue on the upper face of
the bolt, radiating outward from around the firing pin. Never noticed before. I wonder if this
Posted in thread: Strange .22 firing problem... on 04-25-2013 at 05:57 AM
Thanks for the reply. I doubt that the pin or spring is the problem, as the bolt was new,
however I've made that mistake before. I will take it apart to examine the insides.As for the
spacing, it does...
Posted in thread: Strange .22 firing problem... on 04-24-2013 at 11:20 PM
I was asked to take a look at a friends Cooey 600 that he inherited. He encountered some
misfiring when he tried it out. Thought it was really old ammo, as only one of every 5 or 6
fired. I had a spar...
Posted in thread: Bolt won't grab last shell in mag... on 02-05-2013 at 04:46 AM
Well...I think I fixed the magazine. After close inspection, I saw that one of the lips that
actually holds the shells in was slightly bent outwards and allowing the shells to rise a bit
more towards ...
Posted in thread: Bolt won't grab last shell in mag... on 02-01-2013 at 03:30 AM
To be honest, I thought the spring was weak. The tabs look o.k. and the follower is inserted
the correct way. I was actually thinking of soldering a thin piece of steel onto the follower
on top of the...
Posted in thread: Bolt won't grab last shell in mag... on 01-31-2013 at 07:54 PM
I was asked by a good friend to "fix" his .22, a Squires Bingham model 16, the one that looks
like an M16. It seems that it will not pick up the last shell in the magazine. Looking at it
from the side...
Posted in thread: Butt plate trap door hinge pin... on 11-16-2012 at 03:58 AM
I am trying to repair a BSA .303 cal rifle for an old friend. The trap door in the butt plate
is slightly bent and it stands above the plate when closed. I thought I could remove it to
flatten it flus...
Posted in thread: Gun stock protection with wood hardener? on 10-23-2012 at 05:53 AM
Thanks for your response. I had planned on using water based walnut stain and finish with
Tru-Oil. If I try to screw an end cap on, I don't think the screws will hold. I think if I can
set it up verti...
Posted in thread: Gun stock protection with wood hardener? on 10-22-2012 at 04:59 AM
I have been given a B.S.A. 303 to fix up as a gift and have encountered a situation that
requires some help. As a machinist for many years, I have been asked to repair metal gun parts
many times, but ...