Gift Premium Subscription To jebsca

Join Date:


Last Activity:

09-13-2015 11:33 AM

Likes Given: 42

34 Likes on 27 Posts 


  • Posted in thread: Brass Trader on 01-06-2015 at 08:14 AM
    I have bunches of 9mm once fired and quite a bit of millitary 5.56 to trade.I need 40 s@w38
    spec10mm41 mag454 casullI can trade more than even on everything pm and we can discuss a fair
    trade. I have ...

  • Posted in thread: 10mm Accurate #9 and 200 gr XTP on 10-11-2014 at 11:46 AM
    Found this: shows loading from 12.0-13.0 with nothing about compressed load. Did the book say
    anything about compressed load? It might be a good time to look into that country of origin
    thing.Think I...

  • Posted in thread: Review Farrar Ballistics 38 SPC reman on 07-31-2014 at 12:18 PM
    Would be interesting to check out the rounds looking at the OAL, case length, case diameter,
    the bullet weight and diameter, and how consistent the powder drops were. If I read this right,
    you did get...

  • Posted in thread: Hornady Progressive Press versus Dillon 650 on 07-23-2014 at 12:32 PM
    I have the Hornady LNL, and am very happy with it. If you don't want to get bushings for ever
    die, you could just leave them in, and reset up your dies every time. If you do get the
    bushings for every...

  • Posted in thread: Looking to start reloading on 02-15-2014 at 03:03 AM
    You are talking about a few good ways to need a LOT of ammo every week. That does point to
    going progressive. Just don't be the guy we all know (or maybe we are that guy) that gets the 1
    ton truck cau...

  • Posted in thread: Wrong primer now what?? on 02-12-2014 at 07:09 PM
    I pulled bullets from some ammo given to me (new cases, old timer loaded them, was slipping
    mentally- so loads of questionable build- verified as dangerous upon dis assembly).Sized 'em,
    which knocked ...

  • Posted in thread: Newbie reloader checklist on 02-12-2014 at 10:32 AM
    I use the gauge and holder from lee along with the lee large case trimmer and lock stud. Put it
    all together, put it in a drill and knock em out fast. Just run the drill til it stops cutting,
    put the ...

  • Posted in thread: Welcome a new ammunition storage idea on 02-12-2014 at 03:29 AM
    As I look at this, I question how reusable this is. In my mind, storing a small quantity like
    listed on the website is a short term storage, and will be open back up later only to replace
    the ammo in ...

  • Posted in thread: Wrong primer now what?? on 02-12-2014 at 02:38 AM
    I deprimed a few with live primers over the years but nothing like that many. Usually it was
    when a primer got turned around and seated backwards. I can't advise anyone else but I would
    probably break...

  • Posted in thread: Newbie reloader checklist on 02-10-2014 at 04:05 PM
    As for the case mouth tool, I didn't see anything about trimming tools. After you trim the
    cases, you need to dress up the mouth. If you are not going to trim, you should be good. With
    most pistol cas...