Last Activity:10-16-2015 9:55 AM
Likes Given: 1
Posted in thread: Remington Model 799 on 10-13-2015 at 03:32 PM
I have a Remington Model 799 in a .22-250 caliber, the bolt closes fine when there is no shell
in the chamber but as soon a you bolt a shell into the chamber the bolt will not close. Idea on
what the ...
Posted in thread: Winchester Model 1892 on 03-26-2015 at 10:45 PM
I may sound stupid but what does "Dress" the bolt end meanSorry
Posted in thread: Winchester Model 1892 on 03-25-2015 at 05:09 PM
I took the bold out as you recommended and the bolt slides freely. As I was putting it back
together there is a screw that had to be removed for me to tap a pin out to remove the lever,
when I put the...
Posted in thread: Winchester Model 1892 on 03-24-2015 at 05:22 PM
I have a Winchester Model 1892 in a 25-20. The firearm levers very hard, to the point it almost
takes two hands to cock it. It has been thoroughly cleaned.Any ideas on what might be causing
Posted in thread: Premier Trail Blazer on 12-15-2014 at 01:56 PM
Once you slam the pump ahead it locks everything, including the trigger, so you cannot dry fire
it. The hammer is not exposed.Thanks for the help so far.
Posted in thread: Premier Trail Blazer on 12-14-2014 at 03:40 PM
I have a Premier Trail Blazer, pump, with octagon barrel, from what I have read, it could be
the same as a Savage model 29A. When you slam the receiver all the way forward it locks
everything, you can...
Posted in thread: Rossi R243YMB on 11-17-2014 at 05:12 PM
I have a Rossi single shot .243, the problem I am having is that every 2-3 shots the shell will
not go off and the primer is dented fairly well. I have tried different brands of shells and
the same th...
Posted in thread: Westpoint Model 410 Series K scope base. on 09-27-2014 at 02:01 PM
It is a 30-06 rifle, the serial number is C135XXX. Where the bases screw in, the back one is
flat and the front one (by the barrel) is slightly rounded.I had a pair of Weaver #46 bases and
they fit th...
Posted in thread: Westpoint Model 410 Series K scope base. on 09-26-2014 at 08:16 PM
I have a Westpoint Model 410 Series K, I have bought a scope for it but am unable to find what
bases to use. I have searched the Internet and looked atg most base charts with no luck. Anyone
have an i...
Posted in thread: JC Higgins Model 60 on 12-27-2012 at 02:07 PM
Thanks to everyone for their help. I was able to unscrew the magazine and replace the action
bar that way. The gun works perfectly now.