VIEW MY

gans

Gift Premium Subscription To gans

Join Date:

06-14-2007

Last Activity:

09-26-2008 2:51 PM

    ABOUT ME

  • Custom 1911 Work

LATEST ACTIVITY

  • Posted in thread: Colt 1991 Govt. Model??? Compensator??? on 09-26-2008 at 06:51 PM
    I guess that I can't agree with that, I install comps with more than 3 ports all the time and I
    can see a difference. It all depends on what the customer is looking for. For a racegun, 3-4
    vertical po...

  • Posted in thread: Colt 1991 Govt. Model??? Compensator??? on 09-26-2008 at 01:39 PM
    The discussion was about installing a compensator and the prices are all over the place. The
    link showing the cost of $335 was for the total cost of the comp, installation and all the
    parts to install...

  • Posted in thread: Colt 1991 Govt. Model??? Compensator??? on 09-26-2008 at 09:28 AM
    Here is some reality

  • Posted in thread: 45 acp barrel bushing question on 06-14-2008 at 08:33 PM
    The bushings are usually heat treated and difficult to spread. If you only need to increase it
    a few thousands, you should be able to do it with a tapered punch. It will take a lot of
    pressure. You wi...

  • Posted in thread: Dan Wesson 1911 on 10-01-2007 at 12:32 AM
    I have worked on a couple of them. They were machined quite nicely and had good fitting of
    parts.

  • Posted in thread: What's your take on Shok-Buffs? on 07-19-2007 at 02:29 PM
    I guess that it would be more safe not to use shock buffers if the shooter is not going to
    check them and is going to use the correct recoil spring for the specific load that they are
    using.But for th...

  • Posted in thread: What's your take on Shok-Buffs? on 07-01-2007 at 12:33 PM
    Dgunsmith,You made some good points. Would you elaborate on them, to help us make an informed
    decision on the use of buffs.1- On the extensive LE tests. If the buffs were replaced when
    signs of wear o...

  • Posted in thread: What's your take on Shok-Buffs? on 06-30-2007 at 02:06 PM
    Good insurance, just keep an eye on them for wear.

  • Posted in thread: What is the Differece Between These Barrels? on 06-14-2007 at 02:49 PM
    What is the differece between the following 5" barrels?5" standardBullMatch Grade, BullFully
    Supported Ramped, BullI thought there was another one but its not on their web site. Thanks for
    the help.Th...

  • Posted in thread: Guide Rod? on 06-14-2007 at 02:39 PM
    Which is better: the factory short or the after-market full length rod? Will the full length
    add anything in the performance area? I've read and heard different stuff but don't know where
    to draw the ...

0 COMMENTS
POST A COMMENT