fsted2a

Gift Premium Subscription To fsted2a

Join Date:

04-27-2008

Last Activity:

07-14-2017 12:49 PM

Likes Given: 651

390 Likes on 307 Posts 

LATEST ACTIVITY

  • Posted in thread: Curious about the fees of class 3 on 08-21-2017 at 06:11 PM
    Also, if you have a license to manufacture firearms, you have to have Itrs registration through
    the state department.

  • Posted in thread: Lapping the upper receiver and loctite on the barrel extension on 08-21-2017 at 05:59 PM
    - the handguard Im using now flexes, the gas tube also presses against the barrel nut. . The
    gas tube and barrel nut should not touch. You should have your barrel nut backed off,
    re-tightened and alig...

  • Posted in thread: Barrel break in on 07-12-2017 at 04:40 PM
    following is purely my opinion. do with it what you will.barrel break in procedures are on the
    same order of reality as consulting a witchdocter because you need to hex someone with a
    spell.shooting a...

  • Posted in thread: Trouble finding good AR magazine on 07-03-2017 at 03:46 PM
    If you believe anything on You Tube, you would think Magpul had the best magazines.. they seem
    to be everywhere.They're good mags. Lots of folks go many rounds without any problems. Got some
    1st gener...

  • Posted in thread: startup home based ffl inventory software on 06-29-2017 at 01:58 PM
    There are still home based CFL's being issued by the ATF, but many get stopped in the process
    due to zoning, and law enforcement doesn't want a gun dealer in a residential area.. Some get
    around it by...

  • Posted in thread: Accurizing Wedge: legit or scam? on 06-29-2017 at 01:54 PM
    To avoid surprises buyers who may not be mechanically inclined should purchase an assembled
    rifle locally. For the mechanically inclined it is much better to purchase stripped Mil Spec
    receivers local...

  • Posted in thread: Quick AR cleaning question on 06-26-2017 at 01:59 PM
    I have always used solvents like Hoppes to clean my guns, but was recently told they can hurt
    the finish. Should I switch to a CLR like Break Free or Lucas for my AR and pistols? Thanks so
    much!I don'...

  • Posted in thread: Accurizing Wedge: legit or scam? on 06-26-2017 at 01:02 PM
    The trend for receiver fit is going tighter like RRA, etc. but the top dog with matched
    receivers is Les Baer. For average commercial receivers loose is often attributed to the bore
    in the upper recei...

  • Posted in thread: Accurizing Wedge: legit or scam? on 06-24-2017 at 11:58 AM
    A pliable AccuWedge pushing against the takedown pin lug does not tighten receivers however it
    can be used as a buffer. A receiver tensioning screw also centers and pushes against the narrow
    takedown ...

  • Posted in thread: Trouble finding good AR magazine on 06-22-2017 at 09:04 PM
    prevent it from closing if the mag is empty. It's supposed to do that.

Following Stats
FORUM SIGNATURE
"Democracy is two wolves and one sheep voting on what to have for dinner. Liberty is the well-armed lamb contesting the vote." - Benjamin Franklin
1 COMMENTS
Posted: 
January 27, 2013  •  08:09 PM
63X (mechanic Supervisor) Retiring in the beginning of 2014.
 
POST A COMMENT