VIEW MY

ebiss9

Gift Premium Subscription To ebiss9

Join Date:

07-26-2014

Last Activity:

05-24-2017 8:09 PM

Likes Given: 9

17 Likes on 14 Posts 

LATEST ACTIVITY

  • Posted in thread: Lead bullets in 9mm on 03-22-2017 at 06:15 PM
    Just to note, I've read lead bullets are not recommended for octagonal polygonal rifling.
    Glock, in particular, advises against the use of lead bullets and polygonally rifled barrels.
    H&K and Kahr are...

  • Posted in thread: What did you do at your bench today? on 01-31-2017 at 02:15 PM
    Went downstairs, rolled up the dust cover I have over the reloading bench, looked at all the
    crap I had to move before getting started, (boxes of various caliber test loads I haven't tried
    yet and wha...

  • Posted in thread: identifying ringers in used military brass on 01-09-2017 at 11:03 AM
    Of the multiple thousands of brass I have resized and deprimed, which included crimped Military
    brass up to 50 BMG, I've only had 1 or 2 of which the primer wasn't fully removed. I only
    noticed it whe...

  • Posted in thread: identifying ringers in used military brass on 01-07-2017 at 11:33 PM
    I believe all you're seeing is primer crimp lines........

  • Posted in thread: New Territory on 12-30-2016 at 02:22 AM
    Thanks to all for the comments and valuable information. There are a few things mentioned above
    that I wasn't aware of. I selected the stainless steel model to try and keep corrosion in
    check. I also ...

  • Posted in thread: New Territory on 12-27-2016 at 12:55 PM
    I’ve been an avid shooter most of my life and a center fire cartridge reloader for at least 25
    years but have always wanted to try “cap and ball” target shooting. I spent quite a bit of time
    researchi...

  • Posted in thread: Case length on 08-18-2016 at 11:16 AM
    1.760" is the maximum case length. 1.750" is the trim-to length if they are over the max
    length. I personally trim all my .223/5.56 brass to 1.750" during the reloading process. This
    makes the bullet ...

  • Posted in thread: Brass Polishing Question on 07-21-2016 at 01:12 AM
    I'm not knocking you at all sir. Thanks for your service as well. I know I was damned happy to
    see F4 Phantoms coming in to save our bacon in 1968. I remember we had to keep our tanks
    ridiculously cle...

  • Posted in thread: Brass Polishing Question on 07-20-2016 at 10:07 PM
    Well, I asked him about his procedures.He says: I weigh each piece of brass and put them in
    declining order.then I weigh each BULLET (projectile) and put them in declining order.I weight
    each individu...

  • Posted in thread: Brass Polishing Question on 07-20-2016 at 12:28 PM
    It's been said that the corn cob media rounds out and loses it cutting power, so to speak,
    after only 2 or 3 uses. I have noticed it takes a little longer to get the same results with
    each consecutive...

FORUM SIGNATURE
We the people are the rightful masters of both Congress and the courts, not to overthrow the Constitution but to overthrow the men who pervert the Constitution. Abraham Lincoln
0 COMMENTS
POST A COMMENT