dteed4094

LATEST ACTIVITY

• Posted in thread: How Much Ammo do you stockpile ? on 05/19/2012 at 3:44PM
  Seriously...if you have no fears of our government, then one can always restock. If you oddly enough, do
  not trust our fine government, then more, a lot more, might be in order.I don't see what is odd...

• Posted in thread: Walnut stock? I don't know wood. on 05/05/2012 at 6:51PM
  Tung oil is basicaly the same as BC. It too has to dry. You can start with BLO (boiled linseed oil) to
  bring the wood back to life then use Tung oil. I usuallu wind up with around 20 coats. Use 0000 s...

• Posted in thread: Mosin thread on 05/02/2012 at 12:59PM
  If it weren't for the cosmoline that many of you hate, most of these Mosins that you have become endeared
  to would be rusted piles of junk.

• Posted in thread: moison nagant on 04/22/2012 at 7:31AM
  An arshin is approximately 28 inches, The average length of a Russian soldier's stride.

• Posted in thread: Stock set advice, Mac 90 on 04/21/2012 at 1:37PM
  I have a Norinco Mac 90 with origional wood handguard and thumb hole stock. To be perfectly honest, I
  cant reach the trigger while appropriately gripping the rifle (short fingers). I am interested in ...

• Posted in thread: Don't Do That Dudes on 04/14/2012 at 2:52PM
  I introduced my to pistols with my Ruger Single Six. Her Dad introduced her to rifles long before I was
  around. 99% of my shooting is rifles and some but not a lot with center fire pistols. I inherite...

• Posted in thread: Mosin Nagant stuck bolt question on 03/30/2012 at 10:36AM
  Make sure the cocking knob is not in the safe position, the gun does not have a round chambered, break
  the rifle down as far as you can lncluding the trigger and sear, put it firmly in a vise and put ...

• Posted in thread: Just ordered my Mosin!!! on 03/29/2012 at 9:45PM
  The last can I got from Aim Surplus was less than $90 shipped to my door in 3 days.

• Posted in thread: Just ordered my Mosin!!! on 03/28/2012 at 4:30PM
  Aim surplus just got a new shipment of 91/30s about a week ago. As for the can opener, I have one, I
  think a hatchet and a hammer works better. Just be careful.

• Posted in thread: Just ordered my Mosin!!! on 03/27/2012 at 6:59PM
  The easiest way to bring your group down: get some of that shrinkable wire insulation, slip it down
  through the hole in the frount sight shroud,hit it with a bic lighter, cut it about an eigth inch ab...