Last Activity:02-24-2014 2:49 PM
Posted in thread: 270 Winchester reloading on 01-23-2012 at 07:32 PM
I know the action screws are tight and I guess I could try a dedication copper remover since I
use a powder and copper remover.
Posted in thread: 270 Winchester reloading on 01-23-2012 at 05:25 AM
I am getting speeds around 3070 and I have never calculated a standard deviation. The gun is
bedded and floated. The crown appears to be in good condition. The overall length is the same a
factory. I ...
Posted in thread: 270 Winchester reloading on 01-22-2012 at 10:48 PM
Ya, I have a chronograph.
Posted in thread: 270 Winchester reloading on 01-22-2012 at 07:04 AM
No, I haven't shot any factory ammo through the gun in a while. The groups have always been
good enough for the hunting I do, but recently I have been putting more effort into reducing my
Posted in thread: 270 Winchester reloading on 01-20-2012 at 07:24 AM
I was wondering if people had their own opinion about this topic. I am shooting a ruger m77
mkII. Shooting a 130 gr nosler ballistic tip boat tail bullet with 54 grains of imr 4831 powder
Posted in thread: Rifle barrel and part. on 12-26-2011 at 04:59 AM
I agree. It does look nice polished, but I agree with you that will take a lot of time and
maintenance to keep it from rusting. I am just going to reblue the gun.
Posted in thread: Rifle barrel and part. on 12-25-2011 at 10:12 PM
I am new to this forum, so I hope I am posting this in the right spot. I was wondering if there
was a solution or some method to put on all of the steal parts to make them not rust. I was
going to reb...