Last Activity:08-21-2010 6:01 PM
Posted in thread: Having trouble workin up loads. on 08-24-2010 at 02:35 AM
GD,I will do some more investigation into shooting with the windage flags and c what happens.
As far as the scope I think I have a book that discusses parallax problems with scopes. I will
reread it a...
Posted in thread: Having trouble workin up loads. on 08-22-2010 at 12:01 AM
Thanks for the info. I have been looking at diff. Loads and h380 for a powder was one I was
looking at. I have still have some other ideas like RL-15 also.
Posted in thread: Bullet seating. on 08-17-2010 at 10:18 PM
Fuzzy,For a set up I am very fortunate I have a good set up good beam type scales, press and
equipment. Just I have a lack in the process I am self taught I have read hornady 7th issue And
Posted in thread: Bullet seating. on 08-16-2010 at 05:39 PM
Fuzzy, so i would be able to buy diff. brand dies then loader? i was unsure if the threads
would be the same. (wasn't sure if they changed the threads between compaines.) what brand are
you having goo...
Posted in thread: 2 new guns need advice on 08-16-2010 at 07:31 AM
Bio,If your talkin about the mount on the Marlin you should be able to find a scope mount just
about anywhere i think even wally world would have one. they talke a simple clamp on style
think they cal...
Posted in thread: Bullet seating. on 08-16-2010 at 02:19 AM
"Consistency equals Accuracy, Accuracy equals consistency!"If a load doesn't match the rifles
need's, consistancy of the load only equals consistant inaccuracy. Meaning that great
consistancy, of itse...
Posted in thread: Having trouble workin up loads. on 08-15-2010 at 10:45 PM
cpttango30 thanks for the load data. And charlie i have never shot any factory ammo through it
so i don't know. I have been thinkning about buying some quatlity ammo and seeing what happens.
not sure ...
Posted in thread: Bullet seating. on 07-31-2010 at 08:41 AM
I am not loading a compressed load. And I am currently looking at a L-N-L gages to measure from
the ogive. I am currently using calipers to measure my COL. If any thing was to blame i would
say it lay...
Posted in thread: Bullet seating. on 07-28-2010 at 07:06 AM
Hunter,Thanks for the info I will look at my mounting system and c if it rocks. And I am using
boat tail bullets and chamfering the cases. The dies are rcbs I check for small pieces of brass
in it but...
Posted in thread: Bullet seating. on 07-28-2010 at 02:23 AM
When I was working up more loads I started to notice that my Die is seating bullets with .005"
(+-). Ex: C.O.L. 2.330-2.335 is this normal? Or could this b some part in my accuracy problem?
I do not h...