cvriv

LATEST ACTIVITY

• Posted in thread: Show off your gear? Ill go first on 03/16/2012 at 12:39AM
  Thats sweet!

• Posted in thread: Made a Kydex sheath for my Ranger's Edge. on 01/30/2012 at 1:14PM
  Decided to try and make a sheath for my Ranger's Edge and it turned out pretty well in my opinion. Took
  me 2 days to make. Didnt make any belt clip or anything. Just stuck with paracord only because y...

• Posted in thread: A holster I made for my Glock 21/ x300 weapon light,... on 10/09/2011 at 12:32AM
  Fits so well. It's very comfortable to wear. Im wearing it right now for my fully loaded pistol while
  sitting in my chair and I hardly even know its there. Stays flush with my body thanks to the 4 bel...

• Posted in thread: A holster I made for my Glock 21/ x300 weapon light,... on 10/09/2011 at 12:28AM
  As done as this holster is going to get. Holsters the gun beautifully, fits and feels amazing as the
  first one. A total win. I am not going to sand this down like I did the first one. To be honest I l...

• Posted in thread: A holster I made for my Glock 21/ x300 weapon light,... on 10/07/2011 at 3:43AM
  Got some work done. Almsot done with this bad boy,...

• Posted in thread: A holster I made for my Glock 21/ x300 weapon light,... on 10/07/2011 at 3:08AM
  Almost done with the next one. Pics in a minute,...

• Posted in thread: A holster I made for my Glock 21/ x300 weapon light,... on 10/06/2011 at 2:15AM
  

• Posted in thread: A holster I made for my Glock 21/ x300 weapon light,... on 10/06/2011 at 2:14AM
  Retension screws are below the trigger.

• Posted in thread: A holster I made for my Glock 21/ x300 weapon light,... on 10/06/2011 at 2:11AM
  Ok the shell is pretty much done. I just have to clean out the inside more because it holsters a bit
  snug. Probably as snug as I would have it if I was carrying. The holster has retention screws so I ...

• Posted in thread: A holster I made for my Glock 21/ x300 weapon light,... on 10/05/2011 at 2:35PM
  Here's the next holster im working on. I have the design already cut out of the kydex. I just have to
  form it now. It's looks very minimal. I have made some slight changes. This is mockup is only show...