VIEW MY

almostgem

Gift Premium Subscription To almostgem

Join Date:

10-19-2011

Last Activity:

04-09-2014 6:27 AM

LATEST ACTIVITY

  • Posted in thread: Gunbot on 03-28-2013 at 11:06 AM
    Was going to post the same, but without the 9mm. It shows status for all kinds of ammo, not
    just 9mm reloading supplies and large cap magazines.

  • Posted in thread: MyGunDB Giveaway! on 07-15-2012 at 09:43 PM
    Please put my name in the hat too ! :)Thanks so much

  • Posted in thread: Looking for bullet casting lead. on 06-30-2012 at 12:39 PM
    If you're patient, you can sometimes get some decent deals on Ebay. Get yourself an auction
    sniper tool for your phone or computer and look for lynotype or monotype lead. You can also get
    "bhn tested"...

  • Posted in thread: Can't find a recipe for 9mm luger on 06-30-2012 at 12:04 PM
    My Taurus FS92 likes 5 gr of power pistol over 1.130 oal, but I'm firing 124 gr lead. As far as
    OAL is concerned, the best way to find the correct OAL for the bullet you are using, is to
    remove your b...

  • Posted in thread: the best heavy barreled .22 on the market you decide on 04-04-2012 at 12:00 AM
    I have to agree with the old man. My 10/22 is a real tack driver at 100 yards. I've done a few
    tweaks though. 18 inch bull barrel, hardwood thumbhole stock. 2 1/2 lb pull trigger and a 2 x 9
    x40 scope...

  • Posted in thread: 45 cal issue. on 01-20-2012 at 12:24 PM
    Thanks Rick,I'll head on over to Midway and get a couple of the case gauges. I also have some
    9mm lead that I recently picked up.I haven't attempted anything with those, as this last
    episode rattled m...

  • Posted in thread: 45 cal issue. on 01-11-2012 at 01:23 PM
    Combination of Ultrasonic then Walnut. I likes it shiny !Thanks, It's actually just crimped
    using the factory crimp die. Sorry about the fuzzy picture. I was too lazy to pull out my
    camera, and opted ...

  • Posted in thread: 45 cal issue. on 01-10-2012 at 01:32 PM
    Thanks robocop, That was my job this morning.What I found, was that because of the way the
    bullet was shaped, It wasn't seating properly.Now I truly understand why you measure from the
    ogive rather th...

  • Posted in thread: 45 cal issue. on 01-09-2012 at 07:34 PM
    Hi everyone. I reloaded some 45 acp +p small primer cases with 7 grains of power pistol, and
    230 grain lasercut lead round nose bullets. I fired 2 with apparently no difficulty, then the
    slide complet...

  • Posted in thread: New Reloading Setup on 01-05-2012 at 01:24 PM
    Also, do you know the best way to check the OAL for a cartridge ? It should be the longest that
    will reliably feed and as close to the lands as possible. Make a couple of dummy rounds No
    powder or pri...

0 COMMENTS
POST A COMMENT