VIEW MY

Aderondacker

Gift Premium Subscription To Aderondacker

Join Date:

11-24-2008

Last Activity:

01-22-2014 7:44 PM

1 Likes on 1 Posts 

    ABOUT ME

  • Retired

LATEST ACTIVITY

  • Posted in thread: Remington Fieldmaster Firing Pin Replacement on 12-28-2012 at 01:38 AM
    Pin punches that small usually bend then break, find a 1/16" nail set punch, start the pin with
    the nail set and finish up with a pin punch. Hammer size does matter, if the hammer you are
    using doesn'...

  • Posted in thread: Remington rifle Model 7600 on 12-27-2012 at 12:12 PM
    The pin is held in by the ejector port cover. Item #15 on schematics, usually made of plastic.
    When you slide the bolt back into the receiver the port cover slides in with the bolt and it
    moves back a...

  • Posted in thread: JC Higgins Model 60 on 12-27-2012 at 02:43 AM
    The barrel is thread into the receiver and it is tighten tight. I tried a barrel vise and made
    a special wrench for the receiver. I could not get it to budge. I quit before I twisted the
    receiver. Yea...

  • Posted in thread: remington model 7600 on 12-27-2012 at 02:00 AM
    If you are asking what keeps the pin from falling out it is the Ejector Port Cover, usually
    made out of plastic.Aderondacker

  • Posted in thread: Blueing Maleable Cast Steel on 12-27-2012 at 01:29 AM
    Sounds like the Winchesters 94 with serial # 2,700,000 or higher. Winchester plated those
    receivers with steel to get them them to blue but the bluing action eats up the plating. I have
    been leaving t...

0 COMMENTS
POST A COMMENT