Gift Premium Subscription To Roverhound

Join Date:


Last Activity:

10-22-2016 6:13 AM

Likes Given: 1

3 Likes on 3 Posts 


  • Stuarts Draft, Virginia
  • Target shooting, Fly fishing, Off road driving, camping


  • Posted in thread: Trigger reset on 10-15-2016 at 10:35 AM
    Are the springs to light? Are the trigger and hammer pins backed out at all?I've had both. The
    trigger pin on my Eagle 15 would back out causing a misalignment that wouldn't let it reset.I
    did the "15...

  • Posted in thread: Optics suggestions. on 10-12-2016 at 09:41 AM
    The Primary Arms is going to be a good scope; here is another option that I think you'd be
    happy with

  • Posted in thread: Bolt not staying open on 09-23-2016 at 09:53 AM
    How was the bolt defective? What bolt was it?

  • Posted in thread: AR picture thread on 08-19-2016 at 12:00 PM
    Then build an upper and swap that out....Then have two rifles!:)

  • Posted in thread: AR .223 OK for Mini? on 07-27-2016 at 12:32 PM
    I shot plenty of the Federal AR223 as well as the AR556 out of my 196 series Mini.The slight
    edge to accuracy goes to the AR223 but either one shot well.

  • Posted in thread: Palmetto State Armory shipping on 07-22-2016 at 07:05 PM
    Lastly, I didn't "dig up" a 2 year old post. I simply googled "PSA shipping times" and happened
    to come across MANY complaints.That's the very definition of digging.:pSorry you're stuck in
    California ...

  • Posted in thread: Palmetto State Armory shipping on 07-21-2016 at 09:08 AM
    I don't think it's fair to ding them for being slow, if you were shopping for the cheapest
    option.Especially for a single 90 round box of ammo. Walmart likely has it. Why would someone
    order such a sm...

  • Posted in thread: My first build on 07-20-2016 at 12:49 AM
    I have this set but you can probably get away with something that doesn't have as many.This set
    has both roll and pin

  • Posted in thread: My first build on 07-19-2016 at 05:09 PM
    An ar armorers wrench, hammer, roll pin punches ( you can do it with regular punches but these
    make it easier and less likely that you will scratch your finish), pliers, an upper vise block,
    allen key...

  • Posted in thread: My first build on 07-19-2016 at 11:20 AM
    The barrel assembly you listed already has the delta ring. You will need it with the hand guard
    you listed.Also, that barrel assembly will already have a barrel nut if it is coming assembled
    as pictur...