VIEW MY

GunDoc

Gift Premium Subscription To GunDoc

Join Date:

03-27-2011

Last Activity:

02-25-2014 8:19 PM

Referrals: 1

Likes Given: 6

9 Likes on 7 Posts 

    ABOUT ME

  • Townsend,Montana Territory
  • Gunsmith

LATEST ACTIVITY

  • Posted in thread: Improving the Mini on 09-27-2013 at 02:16 PM
    Sandog - sounds like you've done a fine job on accurizing. Be sure to bed the new stock to
    complete the work you've done.

  • Posted in thread: Bullet proof fiber board??? on 08-06-2013 at 01:30 PM
    Curious Tri, was the 1 inch piece a solid piece or two 1/2 inch pieces stuck together? I'm
    wondering if like woven armor the first half inch would be penetrated and the second would stop
    it.

  • Posted in thread: Howdy Montana!! on 07-27-2013 at 02:52 PM
    Hello from the Townsend area. I'm out on Canyon Ferry near Confederate Gulch. Hot lately, but
    so far not too bad today.

  • Posted in thread: What is required to become a professional gunsmith? on 04-05-2013 at 01:42 PM
    c3shooter is on the money. I don't need a business license where my shop is and the county
    didn't require any special permits. The state wanted me to register as a business but that was
    all. So check ...

  • Posted in thread: Help? on 03-21-2013 at 01:26 PM
    I had room on my Bushmaster to mount a 512 and a buis by allowing the 512 to extend over the
    railed handguard a little. Since the buttons on mine are on the back of the model it was the
    only way to le...

  • Posted in thread: screw stakes on 03-20-2013 at 01:42 PM
    will help you. Just use a 9/64" Allen wrench and break them loose one at a time. It'll make a
    lot of popping noise and an occasional spark may jump out, but unless the factory cross
    threaded them (i...

  • Posted in thread: smith help??? on 03-20-2013 at 01:28 PM
    Sometimes the sights you prefer won't fit the dovetail of the slide. A simple dovetail file
    from Brownells will allow you to modify the dovetail or the sight for a good fit. I prefer to
    modify the sig...

  • Posted in thread: Gunsmithing Tools: Your suggestions please! on 08-27-2012 at 12:54 PM
    Do you know if he does specific gunsmithing such as rifles or pistols? As a gunsmith he
    probably has everday gunsmithing tools and a Brownells or MidwayUSA (gunsmithing supply
    companies) gift card wou...

  • Posted in thread: What do you use to change the hammer spring? on 08-03-2012 at 01:14 PM
    I just use my Brownell's VersaVise. The smooth face and square edges work perfect for me by
    dropping the front jaw down a little. I have a lot of experience working on Minis now, but I
    launched a few ...

  • Posted in thread: MyGunDB Giveaway! on 07-15-2012 at 05:30 PM
    Thank you!

FORUM SIGNATURE
Great West Gunsmithing www.thegundoc.com
0 COMMENTS
POST A COMMENT