Last Activity:04-17-2016 11:06 PM
Likes Given: 12
10 Likes on 8 Posts
Posted in thread: Smith 36 half cocked? on 04-11-2016 at 09:51 PM
Diesel Fuel leaves a heavy residue and must be removed with a solvent. There are many modern
Action Blasters that are of low viscosity an active solvents that dry quickly with zero
petroleum residue. ...
Posted in thread: Smith 36 half cocked? on 04-02-2016 at 12:02 AM
Get yourself @ GoodWill a pan just large enough to hold your Model 36. Remove your grips.Cover
in Diesel Fuel overnight/couple of days.Operate action a couple hundred times in Single +
Posted in thread: What Am I Doing Wrong? on 02-20-2016 at 11:27 PM
A picture of the projectile that you are using would help.All SWC cast bullets that I have
loaded get seated to the crimp groove (Top groove just below the bullet nose)Titegroup powder
never has, and ...
Posted in thread: Powder Coat Anyone?? on 02-19-2016 at 01:19 AM
*link to outside forum removed*^^^I've been getting into this "System".Makes for some GREAT
projectiles, especially handgun loads. Can be ran through ANY handgun=Glocks INCLUDED. No lead,
clean bore, ...
Posted in thread: Making our own bullets on 02-19-2016 at 01:11 AM
I've loaded for over 40 years. Cast bullets for right at 30 years..After getting into this:
now am a Powder Coat loader/shooter.This system is CHEAP to get into, and it WORKS..Bill.:)
Posted in thread: Reloaders quality opinions on 02-19-2016 at 12:35 AM
:DI've loaded on my RL550 for somewhere around 30 years.. Been good to me.Keep in mind that the
650 caliber conversions+die block prices are WAY HIGHER than the 550...Bill.:)
Posted in thread: mini 14 on 10-28-2013 at 03:59 AM
Posted in thread: S&W Question on 10-28-2013 at 03:56 AM
You got a nice Model 36 there..One of the most popular carry guns EVER!!..If that was MY carry
gun, I would go over to GunBroker.org and buy a hammer, either a bobbed one, or bob it
yourself. Save the...
Posted in thread: Reloading 357 Mag? on 10-28-2013 at 03:41 AM
Thanks guys for all the tips. I think I'll order some cast bullets from Missouri Bullet
Company. I saw some bullets there I'd like to try in my 1911 too. :DYou will like MBC for all
of your cast needs...
Posted in thread: how do you remove a stuck case from a die?........... on 07-03-2013 at 04:50 PM
Update:After spending part of my saturday shoppin' for a brass punch. (only to learn that they
are almost as expensive as a new set of dies) I have contacted RCBS and have asked them if I
can send my ...