Last Activity:02-24-2014 10:47 PM
Likes Given: 3
3 Likes on 3 Posts
Posted in thread: need ideas to get XDM sights out on 08-18-2013 at 11:29 AM
I talked with B&J Machine. They are sending me a replacement tool tip free of charge. They also
said that a steel punch is often the only way to get XD sights out. Once the factory sight has
Posted in thread: revolver for wife, concealed carry on 08-18-2013 at 05:45 AM
My wife carries a Taurus revolver in 38 special. I don't remember the model but it is a nice
little short barreled perfect for her handgun. Cost just over $200.
Posted in thread: dpms upgrade question on 08-18-2013 at 05:35 AM
I have a Rock River NM upper on a DPMS lower. I replaced the trigger with a Jewel trigger and
set the pull to 4 lbs. I use this in NRA high power competition and can easily shoot 1 MOA with
it. I also...
Posted in thread: need ideas to get XDM sights out on 08-11-2013 at 08:10 PM
Resorted to grinding an old steel punch to just fit into the dovetail and put the slide into a
bench vise with wood to protect it. After a few test hits with the hammer, I got brave enough
to give it ...
Posted in thread: need ideas to get XDM sights out on 08-10-2013 at 11:51 PM
Bought some night sights for my XDM. I have a B&J Machine P500 sight tool and have used it
successfully on other handguns. When trying to use it on the XDM, the tip of the push rod
shattered and the s...
Posted in thread: LC9 v. XDs v. Nano v. Shield on 07-08-2013 at 07:04 AM
I have a Kimber BP Ten II and an XDM. I prefer to carry the XDM but it is not a huge
improvement in comfort. Still quite a lump IWB if you know what I mean. The XDM came with
interchangeable grip piec...
Posted in thread: Best AK-47/AK-74 Accessories on 07-05-2013 at 09:05 PM
Depends what you want to do with it. I started with a quad rail from Mako and added rail
mounted accessories. It came with a side folding stock or I might have added some after market
Posted in thread: amd 65 trigger on 07-05-2013 at 04:54 PM
I have an AND 65 AK variant. It came with a trigger stamped G2 on the side. I assume it is a
Tapco G2 trigger but the pull is a bit heavy and it feels kind of gritty. Is this how it is
supposed to fee...
Posted in thread: Thoughts on .357 Sig? on 07-03-2013 at 01:20 AM
I used to have a sigpro in 357 Sig but sold it for no good reason. It is basically a 9mm at
higher velocities so your over penetration concern is valid. If you use bullets that expand
readily it will ...
Posted in thread: AR15 Build book on 07-02-2013 at 02:19 AM
I've built a couple of bolt actions on Mauser actions and I own and shoot a rock river AR.
Thinking about trying my hand at building one. Any good books you'd recommend or is that even