Firearm & Gun Forum - FireArmsTalk.com > Search Forums > Search Results

Showing results 1 to 7 of 7
Search took 0.01 seconds.
Search: Posts Made By: drocks101
Firearms Forum: DIY Projects 01-23-2012, 07:32 PM
Replies: 14
Views: 648
Posted By drocks101
I know the action screws are tight and I guess I...

I know the action screws are tight and I guess I could try a dedication copper remover since I use a powder and copper remover.
Firearms Forum: DIY Projects 01-23-2012, 05:25 AM
Replies: 14
Views: 648
Posted By drocks101
I am getting speeds around 3070 and I have never...

I am getting speeds around 3070 and I have never calculated a standard deviation. The gun is bedded and floated. The crown appears to be in good condition. The overall length is the same a factory. I...
Firearms Forum: DIY Projects 01-22-2012, 10:48 PM
Replies: 14
Views: 648
Posted By drocks101
Ya, I have a chronograph.

Ya, I have a chronograph.
Firearms Forum: DIY Projects 01-22-2012, 07:04 AM
Replies: 14
Views: 648
Posted By drocks101
No, I haven't shot any factory ammo through the...

No, I haven't shot any factory ammo through the gun in a while. The groups have always been good enough for the hunting I do, but recently I have been putting more effort into reducing my groups....
Firearms Forum: DIY Projects 01-20-2012, 07:24 AM
Replies: 14
Views: 648
Posted By drocks101
270 Winchester reloading

I was wondering if people had their own opinion about this topic. I am shooting a ruger m77 mkII. Shooting a 130 gr nosler ballistic tip boat tail bullet with 54 grains of imr 4831 powder in...
Firearms Forum: General Rifle Discussion 12-26-2011, 04:59 AM
Replies: 5
Views: 354
Posted By drocks101
I agree. It does look nice polished, but I agree...

I agree. It does look nice polished, but I agree with you that will take a lot of time and maintenance to keep it from rusting. I am just going to reblue the gun.
Firearms Forum: General Rifle Discussion 12-25-2011, 10:12 PM
Replies: 5
Views: 354
Posted By drocks101
Rifle barrel and part.

I am new to this forum, so I hope I am posting this in the right spot. I was wondering if there was a solution or some method to put on all of the steal parts to make them not rust. I was going to...
Showing results 1 to 7 of 7