Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Mini-14 Forum (http://www.firearmstalk.com/forums/f95/)
-   -   New magazine problem (http://www.firearmstalk.com/forums/f95/new-magazine-problem-63138/)

Supermedicjmoyer 04-23-2012 09:32 PM

New magazine problem
 
I bought a used, 196 series, mini 14 Ranch last year. I beleive the stock is a Choate, has a fixed pistol grip buttstock. The shop had three 20 round, factory mags in stock. They were new in the original white card board box. The side of the magazine is stamped "restricted law enforcement/government use only". I assume these magazines were manufactured during the AWB, so they're a little old. These three magazine work beautifully in my Mini. They easily snap into position. When I push the magazine release these mags will pretty much fall right out. I've had zero malfunctions.

I just bought a new Ruger factory magazine (20 round) from Midway USA. The first couple times I inserted the magazine into the mag well it was tight...very tight, and a little tough to snap into place. It was even harder to remove the magazine. I've since inserted and removed the magazine about 30 times. It's easier to insert, still a pain to get out. This new mag is a very tight fit, where as the three older mags actually have a little bit of wiggle room.

Is this a common problem re: newer mags in an older mini? Did I get a factory mag that was a tad out of spec?

1911Jeeper 04-26-2012 09:50 PM

It could be your Mini or it could be the magazine. Get out your calipers and make some comparison measurements. Since you purchased from Midway, explain to customer service that your magazine doesn't fit, and ask them to exchange it. They should do that for you quickly and politely.

.

tri70 05-07-2012 11:00 AM

I have a 196 series also, the mags should fit the same. Do you have a buddy that has a mini to test on or can you that back to the shop and see if they have a mini on shelf to test with? They all should have a little wiggle, factory mags from old should be the same as the new.

Ranger-6 05-07-2012 11:43 AM

When I have a tight magazine I smooth out the corners on a belt sander or use sandpaper to shape it for fit.


All times are GMT. The time now is 06:17 PM.

Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.