This is a pic of the suppressor sight set up on my mini (which I just got on a even trade for a Cetme
I have already removed the roll pin and suppressor and want to remove the blade sight which is tight on the barrel. I am assuming that will need to be tapped off but I just wanted to make sure before doing any damage.
The choate (World's Largest Supplier of Firearm Accessories, Gun Parts and Gunsmithing Tools - BROWNELLS
It says in the instal description that it is held in with a set screw.
Is this correct? I thought they were held in with a roll pin through the bottom of the barrell. IF this is the case is it that hard to drill out the barrell to acept the pin? Ort should I have it done prof.?
Obviously the top of barrell has been factory drilled for the blade sight . will drilling out the bottom have adverse affects?
Is the Choate sight any better? Is this even worth the effort?
Thank you gentelmen for any help or opinions
I hope I was clear in the description on I want to do with this project