Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Engraving & Refinishing (http://www.firearmstalk.com/forums/f54/)
-   -   Makers Mark (http://www.firearmstalk.com/forums/f54/makers-mark-57505/)

bulldogfirearms 02-11-2012 08:37 PM

Makers Mark
 
Sorry if this isn't in the proper section or if this has been covered, but i couldn't find anything when searching. I was just wondering what the best way to stamp/engrave my makers mark into a lower receiver. It has to be 1/16'' tall and .003 deep. I just received my type 07 FFL. I dont plan on "manufacturing" very many guns so i would like a cost effective yet professional looking solution. I am mainly going to be building a few ARs for family and acquaintances. I have done a lot of research and am curious about electro-chemical etching? Any input is greatly appreciated. Thanks in advance!

c3shooter 02-12-2012 12:56 AM

Am NOT a manufacturer (am collector) but please check.

Stamping may be required for some cases rather than engraving or etching, Mechanical stamping creates a change in crystalline structure of metal- grind it off, lab can restore it. As I said, I do not know- any manufacturers on here know? If not, call to ATF Firearms Tech Branch over in WV.

bulldogfirearms 02-12-2012 04:37 PM

Yeah I need to call them anyways for a different reason so I will ask this question at the same time. Thanks!


All times are GMT. The time now is 07:43 AM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.