Recently, I have been asked to make a .22 rifle magazine. I run a small 3D printing start up. I have no doubts it can be done and will be a successful project/product. But here is where I am a little concerned and wanted to double check. From what I gather, I WILL NOT need a FFL since the magazine is "not considered" a gun component. Is this correct? I don't think it would be any problem to get a Type 7 FFL if I have to, but why if I don't.
Location: Third bunker on the right,Central Virginia
Liked 10729 Times on 4644 Posts Likes Given: 1751
as I read the FAQ at the ATF website, that does NOT require an 07 FFL.
And you may find an 07 to be more of a hassle (and expense) than you think- Excise tax paperwork, and 07s must also be licensed under ITAR, and pay a fairly hefty fee, even if they do not export firearms.
What we have here is... failure- to communicate.