M44 Scope Mount Question
 

So, I'm sure this is a lame question and I'm wasting your time, but seeing as how you are still reading, I'm guessing you have time to waste.

I was bored and was surfing Ebay ( just lost half of the readers) and stumbled acrossed a listing for a scope mount made to bolt on in place of the existing rear sights. They claim no gunsmithing needed.

Do you think it could work? Would it be sturdy enough to not wobble after one round? It's only $16 with shipping but I'd rather spend it on surplus ammo than a cruddy scope mount.

Here is the link:
http://cgi.ebay.com/NO-GUNSMITHING-MOSIN-NAGANT-SCOPE-MOUNT-FITS-M44-91-38_W0QQitemZ270251623962QQihZ017QQcategoryZ52510QQ ssPageNameZWDVWQQrdZ1QQcmdZViewItem

Can't spek to the specific mount you are looking at, but c&p of a good article on making a M44 into a scout rifle, including this TYPE of scope base: http://www.surplusrifle.com/shooting2005/mosinscoutrifle/index.asp

Good luck- and let us hear how this comes out for you-

Cool Article, Thanks!

even with the scope the M44 is still not going to be a tack driver and is not ment to be.

I think I like the M44 with the original military stock better. I would get a synthetic stock for mine only if the original was in bad shape.

This is the best one I've found for under $80.

MilSurpStuff.com Products

Very firm mount much better than the B-Square or NC-Star scout mounts.

I have 2 and I'm very happy with them.
I don't use the rails, my Mosin's are NOT Tacticool.

That's a whole lot nicer than the one I was looking at. The one I had found looked like cheap junk and I had read that the screws were junk and you needed to replace with steel screws and still add loc-tite. All this and you may still have to rezero before using.