Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Gunsmithing Forum (http://www.firearmstalk.com/forums/f33/)
-   -   Ruger Blackhawk sight blade (http://www.firearmstalk.com/forums/f33/ruger-blackhawk-sight-blade-26521/)

Trooper 04-27-2010 01:42 AM

Ruger Blackhawk sight blade
 
I have a Ruger New Model Blackhawk that I broke the rear sight blade. I searched the internet as I was having trouble installing the blade as it has a little nipple. The only advice I could find is that the rear sight assembly should have a half-moon cut-out. The instructions were to compress the spring, slip the sight blade in and then install the screw. The only problem is my gun does not have a half-mood cut-out for the sight blade to slide down in to. I thought of filing the nipple off of the blade and thought better of it as it would have nothing to hold it in. I know I can buy the entire sight assembly for $15 bucks, but 15 is 15 and I would rather spend 3 on the blade. Can anyone give me a tip on how to conquer this. Thanks in advance for all help.

danf_fl 04-27-2010 07:11 AM

However you decide to do it, do it correctly. A Smith's hourly wage is more than $15 an hour.


All times are GMT. The time now is 05:32 AM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.