Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Gunsmithing Forum (http://www.firearmstalk.com/forums/f33/)
-   -   Ruger 10/22 Auto Bolt Release (http://www.firearmstalk.com/forums/f33/ruger-10-22-auto-bolt-release-17873/)

BigByrd47119 09-10-2009 12:04 AM

Ruger 10/22 Auto Bolt Release
 
Hey everyone. Just got done browsing around on youtube when I came across this video:

I have no idea if this will infact work and was hoping to get some input on this before I try it out. Thanks ahead of time!

jeepcreep927 09-10-2009 10:52 AM

Quote:

Originally Posted by BigByrd47119 (Post 157509)
Hey everyone. Just got done browsing around on youtube when I came across this video: Modding Ruger 10/22 for Auto Bolt Release at Home!

I have no idea if this will infact work and was hoping to get some input on this before I try it out. Thanks ahead of time!

Yes it works. I used directions off rimfirecentral.com to do mine. Good luck.

stalkingbear 09-10-2009 06:03 PM

I modify all my 10/22 bolt releases like that. It only takes about 2 minutes and is just as good as paying 10-12$ for an aftermarket release. Be aware that a hard thump to the buttstock WILL release the bolt afterwards.

BigByrd47119 09-10-2009 07:52 PM

Quote:

Originally Posted by stalkingbear (Post 157868)
I modify all my 10/22 bolt releases like that. It only takes about 2 minutes and is just as good as paying 10-12$ for an aftermarket release. Be aware that a hard thump to the buttstock WILL release the bolt afterwards.

Good to know. Thanks for the input guys. Now just to go find a dremel bit...

agoetz2005 11-10-2009 12:20 PM

for the start I use a flat needle file. The very pointy tip of the part your dremeling off can cause your bit to jump around.

Get the area flattened off and started, then switch to your dremel bit.


All times are GMT. The time now is 01:45 PM.

Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.