Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Gunsmithing Forum (http://www.firearmstalk.com/forums/f33/)
-   -   Remington rifle Model 7600 (http://www.firearmstalk.com/forums/f33/remington-rifle-model-7600-a-77780/)

m1shooter 12-05-2012 04:40 PM

Remington rifle Model 7600
 
What retains the large(outside) cam pin into the bolt/bolt carrier on the 7600 pump rifle? Thanks

danf_fl 12-05-2012 06:26 PM

Take a look at this schematic:
http://www.brownells.com/.aspx/pid=0/sid=118/schematicsdetail/7600_6

Let's see if we can get some part numbers.

hiwall 12-05-2012 07:34 PM

Been years since I had one apart. Isn't that the pin that is held in place with the firing pin?

m1shooter 12-06-2012 12:22 PM

I'm beginning to think it is just held by a tight fit(friction) with the hole. It never reaches the firing pin. The one i'm working on just falls out if tipped over to the side. Perhaps some light peeining?

Aderondacker 12-27-2012 01:12 PM

The pin is held in by the ejector port cover. Item #15 on schematics, usually made of plastic. When you slide the bolt back into the receiver the port cover slides in with the bolt and it moves back and forth with it during operation of the gun.

Aderondacker


All times are GMT. The time now is 04:53 AM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.