Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Gunsmithing Forum (http://www.firearmstalk.com/forums/f33/)
-   -   Mossberg 500 sear spring (http://www.firearmstalk.com/forums/f33/mossberg-500-sear-spring-16888/)

edteach 08-13-2009 06:35 PM

Mossberg 500 sear spring
 
My mossberg will not set the sear to hold the hammer back. I found that the spring is broken in the sear. When I hold the muzzel up in the air the hammer locks when I hold the muzzel down it does not . I took out the hammer and hammer spring and checked it and that was the problem. I need a sear spring, is it much harder to take out the sear?

stalkingbear 08-14-2009 02:49 PM

Mossberg 500s are pretty easy to replace just about every part on them. Just pay close attention on the positioning of the sear & spring & you'll be ok. Here's a link to gunpartscorp with exploded drawing.
Mossberg*|*500*|*e-GunParts.com

edteach 08-14-2009 03:17 PM

Thanks,
 
I took out the hammer and hammer rod and spring. no problem there, but I think I have to take out the disconect and side rod to get to the sear.I am not sure if I can remove the sear with out removing both the DC and the rod on the left side. I have not seen the spring being broken, but the sear only moves is gravity or if you put a small screwdriver and move it. no resistance to pushing it into the release posistion. It has to be a bad spring.


All times are GMT. The time now is 07:12 AM.

Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.