Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Gunsmithing Forum (http://www.firearmstalk.com/forums/f33/)
-   -   choate flashhider install mini 14 (http://www.firearmstalk.com/forums/f33/choate-flashhider-install-mini-14-a-84113/)

robehess 02-13-2013 04:02 PM

choate flashhider install mini 14
 
3 Attachment(s)
Hello. I have just purchased a choate flashhider for my mini 14 project and wanted to get an opinion. What do you guys think is the best way to make sure the front site on the flashhider is in line with the rear sight?

Here are some pics.

Cattledog 02-13-2013 04:19 PM

I would say a laser boresighter. preferably the chamber mount kind. Other than that:

you can take fishing line and either tie it through the peep sight or create a brace that allows the line to sit centered in the peep. Run the line down the top of the barrel, through the muzzle and down the bore, back to the receiver. Pull it tight and tie off. The inside-top curvature of the flash hider should keep the muzzle end of the line centered. stretch the line so that it balances on the front sight it self. Inspect. The line will allow a better visual to see there is an offset between the front and rear sights. IE: the line should be perfectly straight with no bends, left to right as it balances on the front sight. very low tech, I know.

you can also go though a box of shells. sight at 100

JTJ 02-13-2013 05:47 PM

Isn't there a roll pin that locks the sight into place?

robehess 02-13-2013 09:52 PM

Yea I need to align/level the front blade sight flash hider so it will be aligned/leveled to the front sight, then I can drill the two roll pin holes to complete the install.


All times are GMT. The time now is 11:04 AM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.