Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Gunsmithing Forum (http://www.firearmstalk.com/forums/f33/)
-   -   Beginnerís Gunsmithing Quiz! (http://www.firearmstalk.com/forums/f33/beginner-s-gunsmithing-quiz-69849/)

hoppy70 08-07-2012 06:04 PM

Beginnerís Gunsmithing Quiz!
 
Phase 1: Beginnerís Gunsmithing Quiz!
I am semi-retired and I am taking a self-passed and self-taught Beginnerís Gunsmithing course. I have answered all of questions but during my study and research I am having some problems related to the following quiz questions. Either I am not sure of the correct answer or I have conflicting answers.

Can you help me determine the correct answers for these few quiz questions? Please correct my wrong answers!

Thanks for your help.

7. When using the collimator, remember to:
a) use a loose fitting spud
b) keep the collimator from touching the end of the barrel
c) push the collimator in until it is tight against the crown
d) point the collimator at the sun for accurate results

8. Spring on the collimator spud can be positioned up or down in relation to the barrel. True or False

9. When adjusting dovetailed iron sights remember that the:
a) front sight moves opposite of the point of impact
b) front sight moves the same direction as the point of impact
c) front sight cannot adjust for windage
d) rear sight adjusts for windage only

32. When selecting or building a work bench the two most important factors to consider are:
a) width and height
b) height and length
c) strength and height
d) thickness and length

37. When you are wiping the excess oil off your parts during a clean and oil, it is a good time to:
a) test fit them in the receiver
b) inspect them for wears or breakage
c) polish them for extra measure
d) rinse them again if they are not clean

39. When installing a red ramp the ends of the ramp slot must be:
a) wider at the top than the bottom to keep the ramp in place
b) square to the top of the ramp
c) narrower at the top than the bottom to keep the ramp in place
d) rounded at the top

40. When collimating a scope, the windage, and elevation adjustments:
a) should be near the center of their range when finished
b) do not have to be centered
c) should loc-tited in place when finished
d) can be left where they are

danf_fl 08-07-2012 10:04 PM

7. c. Two points are needed for alignment.
8. I don't know for sure.
9. I don't know
32. strength and height. It needs to be strong enough to support, and it needs to be high enough to work at comfortably.
37. I would think "B"
39. I am unsure
40. I agree with you answer.


All times are GMT. The time now is 07:57 AM.

Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.