Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Gunsmithing Forum (http://www.firearmstalk.com/forums/f33/)
-   -   Action 3 wire roller holder (http://www.firearmstalk.com/forums/f33/action-3-wire-roller-holder-12407/)

ARnoob 03-31-2009 01:56 PM

Action 3 wire roller holder
 
The spring (wire roller holder) on my Action 3 extractor broke (MP5 clone 9mm). Is it difficult to replace? Could someone let me know how or provide me with a diagram explaining this? Thanks! :confused:

ARnoob 04-02-2009 03:23 PM

3 Attachment(s)
Quote:

Originally Posted by ARnoob (Post 89459)
The spring (wire roller holder) on my Action 3 extractor broke (MP5 clone 9mm). Is it difficult to replace? Could someone let me know how or provide me with a diagram explaining this? Thanks! :confused:

Ok, with the help of Tabasco from HKpro, along with some info from other sites, I was able to figure out (for the most part) how to install the "S" wire roller retainer for an MP5 Action 3 Bolt.

The instructions I have are for replacing the older retainer plate, but my Action 3 Bolt uses the "S" wire roller retainer.

It looks like the process should just about be the same to replace both pieces, so 'm going to give it a shot. However, if anyone here has any tips for me, I'd greatly appreciate it! I have included the instructions and diagrams below.


Thanks! :)

ARnoob 04-28-2009 05:35 PM

My wife actually got the wire retainer onto the rollers and into the bolt carrier for me! :p


All times are GMT. The time now is 06:59 PM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.