Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Other Weapons (http://www.firearmstalk.com/forums/f32/)
-   -   Knife sharpening tips? (http://www.firearmstalk.com/forums/f32/knife-sharpening-tips-60736/)

HotFudge 03-21-2012 06:52 PM

Knife sharpening tips?
 
I just bought some honing oil and a medium Arkansas stone and wanna touch up my Skeletool's blade

http://i540.photobucket.com/albums/g...2355430052.jpg

I just want to re-sharpen the straight-edged portion of the blade and the point, don't wanna worry about the serrated portion for now.

dvcguns 03-21-2012 07:29 PM

I have an APEX sharpener that will put a razor edge on any blade but it requires a bit of work (google APEX out of Mt. Hood, OR) so I've taken to sharpening my EDC blades (work blade) with the back side of a 1x30" sanding belt and a Harborfreight $40.00 sander. I just lay down some red ruge on the belt and then work the blade on it a few passes and it's razor sharp again. It will pop hairs after 4-5 passes on each side. Just let the belt do the work.

SSGSF 03-21-2012 08:36 PM

It looks like you have some nicks in the blade? If not it's just the picture. If you have nick in the blade you will need to first start with a corse stone to work out the nicks, then work down to a medium then I a fine stone to finish it to a nice razor sharp look . I use water stones and I start with a 1000 grit and work all way to an 8000. Good luck and have fun .

Dan308 03-22-2012 06:18 AM

EDIT by Moderator-

Dan- we have a provision for vendors here. If you would like to post commercial messages, please contact admin about vendor status.

Marlinman 03-22-2012 06:20 AM

All these are good suggestions. A lansky set will work wonders as well.

God didnt make all men equal colonel Sam Colt did


All times are GMT. The time now is 09:10 AM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.