Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Ammunition & Reloading (http://www.firearmstalk.com/forums/f30/)
-   -   Sizing problem in XL650 (http://www.firearmstalk.com/forums/f30/sizing-problem-xl650-101654/)

Eagle1803 12-16-2013 03:11 PM

Sizing problem in XL650
 
I have a XL650 dillon and I am loading 40 cal. I have the sizing die set according to the book, there really is no adjustment, just screw the die down till it touches the shell plate, I have ran 58 brass hulls though station one, only 14 have sized, I get one here and there that will size . i have ran that sizing die down to the last thread on the Top, still can't get the brass to size. I am also using new dillon dies. any suggestions would be appreciated.:confused:

robocop10mm 12-16-2013 05:43 PM

Is the die punching out the primer every time? What manufacturer made the dies? Dillon presses are thicker than most and dies must be screwed in beyond what you may think proper.

danf_fl 12-16-2013 06:05 PM

Remember, Dillon has a warranty.
Contact them as there may have been some change since you purchased the machine.

Eagle1803 12-16-2013 06:21 PM

Quote:

Originally Posted by robocop10mm (Post 1460410)
Is the die punching out the primer every time? What manufacturer made the dies? Dillon presses are thicker than most and dies must be screwed in beyond what you may think proper.

these are dillon dies, everything works well except the sizing, can't seem to get the whole shell sized, it stops at about a 1/8 to 1/4 inch from the headstamp, you are only suspose to bring the die down to where it touches the shell plate with the handle in the down stoke full stop. I understand you may have to turn it down somemore, but I took all the other dies out so I could see what was going on and had that die screwed all the way down to its last thread and its still not sizing the whole shell and I tryed like 30-40 shells individually, I would get one to size and then the next 7 or 8 would'nt. I am at a lost at this point, waiting for a little advice first then I will call dillon.:confused:

rjd3282 12-16-2013 08:07 PM

Always call Dillon first. They'll have you sorted out in a minute.

gunnut07 12-16-2013 11:08 PM

1 Attachment(s)
WOOO HOLD UP.....

If you had your die touching the shell plate you could have broken the carbide ring. Make sure it is still there first off. NEVER EVER EVER Let the carbide sizing ring on pistol dies touch the shell plate or shell holder. While carbide is strong and slick it is brittle.


Attachment 129555

Eagle1803 12-17-2013 12:44 PM

:rolleyes: I have found the problem, The new Lyman case gage I bought is a defect, I can't hardly believe that but it is true, only in my world.......


All times are GMT. The time now is 02:59 PM.

Copyright ©2000 - 2016, Jelsoft Enterprises Ltd.