Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Ammunition & Reloading (http://www.firearmstalk.com/forums/f30/)
-   -   Powder measure problem (http://www.firearmstalk.com/forums/f30/powder-measure-problem-30186/)

lonyaeger 08-08-2010 01:49 PM

Powder measure problem
 
I have a new powder measure and the instructions say to clean the inside of the main casting and the measuring cylinder and screw to remove the factory applied rust preventative.

The only problem is I've played with it for about 24 hours now and I can't get the measuring screw out so the cylinder will come out.

Can anybody help me?

lonyaeger 08-08-2010 02:03 PM

1 Attachment(s)
forgot to attach photo

hunter Joe 08-08-2010 03:02 PM

Lon, if that is a Uniflow powder measure and I think it is, if you have the large measuring screw installed you have to remove it through the top of the powder measure, although, do not attempt to remove the powder hopper.

In layman terms, turn the dam thing upside down and shake it until the screw falls out.

I hope this was helpful. Joe

lonyaeger 08-08-2010 03:04 PM

Then I have to try to get it back in.....? :eek:

Thanks, Joe, I'll try it. The manual says do not by any means remove the hopper.

lonyaeger 08-08-2010 03:16 PM

Got it, Joe, thanks alot!

Now can you help me with my Rubik's Cube? ;)

hunter Joe 08-08-2010 03:20 PM

Lon, I first pull all those little colored squares off...................


All times are GMT. The time now is 10:24 PM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.