Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Ammunition & Reloading (http://www.firearmstalk.com/forums/f30/)
-   -   bullet casting (http://www.firearmstalk.com/forums/f30/bullet-casting-4553/)

rbdave 05-22-2008 03:22 AM

bullet casting
 
looking for info on casting pistol bullets. have 357 and 44 molds and lots of wheel weights. melting pot ordered but am semi/unfamiliar with process of
adding flux and getting it all ready for pouring. is this all that involved or am i panicking? any help is greatly appreciated.
thanks, rb

jeepcreep927 05-22-2008 04:04 PM

You may want to pick up a book on casting to help you out. There are a few things that the book will make easier like proper temperature and what the appearance of the finished bullet should like etc. Most books will also give ratios of pure lead to antimony to change the hardness of the bullet. There's also info on gas checking and lubing/ sizing. Most important even though obvious, thing is... VENTILATION... Don't melt your lead in the basement without a good source of ventilation and fresh air. I know it sounds like common sense but... well, at one point I guess I lacked common sense as proper ventilation slipped my mind once.

robocop10mm 05-22-2008 05:25 PM

The Cast Bullet Handbook by (I believe) Lyman is a great resource. Get it. Read it. Cover to cover and you will have a great starting point. In 20 years you will still be learning.

+1 on every thing else.

c3shooter 05-23-2008 01:59 AM

Many reloading manuals will have a section on casting- and check the Lee Precision website for instructions- Lee makes a nice bottom tap pot. Do save the cut-off sprues, and out of spec or wrinkled/ frosty bullets- they get recast (but wait until pot is cold- they go in the NEXT melt- splashes). Besides ventilation, remember that lead is HOT- and does not get along well with water getting into the pot (think about water getting into a frying pan of hot shortening- but with attitude) ALSO- pay attention to personal hygiene- do not eat, drink, or smoke while handling lead- or until you go wash well with soap and water. Lead- and lead oxide- will transfer to you skin, and can not only be inhaled, but ingested. And last, but most important- DO NOT use Mom's kitchen range as a heat source. BIG domestic tranquility issue here. Trust me on this one, OK ? :eek: )

cpttango30 05-23-2008 02:54 AM

Head on over to Cast Boolits. There is a bunch of info over there.

1hole 05-23-2008 02:13 PM

"In 20 years you will still be learning." Robo is right about this.

Casting usable bullets is easy enough but even that requires experience. Casting GOOD bullets requires a LOT of experience AND knowledge. Experience/knowledge can be shared in books and on the web but learning to apply what others can tell you will take time and effort on your part.


All times are GMT. The time now is 08:18 PM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.